Jump to content
SAU Community

Recommended Posts

Hi guys, i'm clearing out my hoarded items that either came of my car or never made it onto the car....

I think i have a problem. Here's the items, photos are below.

-Prices are negotiable to a degree.

-Postage price is non negotiable, and is on top of the agreed price. I do not make money of postage.

If i charge an extra few $ on top of postage, its coz i have to find a box, pack it up and wait 40

minutes in my 55 min lunch break to send your parcel.

1 Surge tank to suit 2 bosch 044 pumps. has 2 x -8 JIC fittings to pumps,

2 x -8 on the side and 1 x -8 on top Price - $160

2 Foam Filled Plastic Fuel Tank, never used, conforms to CAMS regs i have been told.

has 2 x -8 JIC fittings for pumps and 1 x -6 for return on the top. - $200

3 6 standard RB25 side feed injectors out of car for about a year - $80

4 Rb25 manual series 2 ECU, will run S1 also - $50

5 Z32 Afm - unknown condition, didnt know i had it - $100

6 2 x sets of Rb25 Cams with cam gears and Solenoids - $75 a set

7 CAS for rb25, again didnt know i had it, comes with bracket, unknown condition - $75

8 RB25 Hydraulic lifters, set of 24, all good condition,

have sat in oil bath for close to 2 years.

didnt make noise when taken out of head - $50

9 Set of good condition std rb25 pistons, no marks on tops of pistons,no rings,

free conrods, conrods are rusted. $50

10 Rb30 crank - has been micropolished, kept this one as a spare in case mine

shit itself, hasnt happened yet, wont need it. $100

11 Chromed RB25 Intake manifold top. removed for plazmaman setup. excellent condition $50

12 3inch dump and frontpipe to suit lowmount KKR430 or kkr480 turbo,

partially heatwrapped. V band with clamp. $200

13 KKR style turbo HOUSINGS. front rear and CHRA. no shaft or blades.

bought as spare, never needed, sold turbo, buyer didnt want spares.

Comes with V band adapter. $100 for all of them

14 Compressor housing off a garret 35/40. 0.7A/R, with anti surge holes drilled.

decided against hacking it up to fit my engine bay. $200

15 Greddy Y-pipe with BOV return welded off. used for 3 dyno runs and

then changed to 1 big 4 inch filter. Was sitting around a bit i didnt wana sell it. $250

16 2 x Genuine Greddy Airinx air filters. 80mm tyres, never used. got wrong colour,

never returned as i bought from USA.both for $170 or $90 each

17 Rb25 O2 sensor. dont use it anymore. $20

18 RB25 VCT sensor, pulled off my head when i did the 30 conversion $50

19 Power FC Boost control solenoid, changed ECU's, was on a RB25 power fc.

only just got this back from the workshop, ecu sold a while ago - $300

OK, i think thats it for now. will add more stuff at a later date. Pictures Below

Contact me on 0401689894 via SMS, or PM (sms will get fastest reply)

Offers welcome

post-50733-1279716240_thumb.jpg

post-50733-1279716252_thumb.jpg

post-50733-1279716260_thumb.jpg

post-50733-1279716268_thumb.jpg

post-50733-1279716277_thumb.jpg

post-50733-1279716305_thumb.jpg

post-50733-1279716315_thumb.jpg

post-50733-1279716321_thumb.jpg

post-50733-1279716327_thumb.jpg

post-50733-1279716332_thumb.jpg

post-50733-1279716339_thumb.jpg

post-50733-1279716344_thumb.jpg

post-50733-1279716350_thumb.jpg

post-50733-1279716356_thumb.jpg

post-50733-1279716362_thumb.jpg

post-50733-1279716368_thumb.jpg

post-50733-1279716373_thumb.jpg

post-50733-1279716379_thumb.jpg

post-50733-1279716385_thumb.jpg

post-50733-1279716391_thumb.jpg

post-50733-1279716396_thumb.jpg

post-50733-1279716401_thumb.jpg

post-50733-1279716407_thumb.jpg

post-50733-1279716413_thumb.jpg

post-50733-1279716422_thumb.jpg

post-50733-1279716427_thumb.jpg

post-50733-1279716433_thumb.jpg

post-50733-1279716442_thumb.jpg

post-50733-1279716456_thumb.jpg

post-50733-1279716462_thumb.jpg

post-50733-1279716476_thumb.jpg

post-50733-1279716483_thumb.jpg

post-50733-1279716490_thumb.jpg

Edited by Gothik33
  • 2 weeks later...
  • 1 year later...

ANNUAL BUMP :domokun: :domokun: :domokun:

JUST BACK FROM OVERSEAS AND FOLLOWING ITEMS ARE STILL LEFT

4 RB25 manual series 2 ECU, will run S1 also - $50

7 CAS for rb25, again didnt know i had it, comes with bracket, unknown condition - $75

8 RB25 Hydraulic lifters, set of 24, all good condition,

have sat in oil bath for close to 2 years.

didnt make noise when taken out of head - $50

10 Rb30 crank - has been micropolished, kept this one as a spare in case mine

shit itself, hasnt happened yet, wont need it. $100

13 KKR style turbo HOUSINGS. front rear and CHRA. no shaft or blades.

bought as spare, never needed, sold turbo, buyer didnt want spares.

Comes with V band adapter. $100 for all of them $50

16 2 x Genuine Greddy Airinx air filters. 80mm intake diameter, never used. got wrong colour,

never returned as i bought from USA.both for $170 or $90 each $150 both, $75 each

17 RB25 O2 sensor. dont use it anymore. $20 $15

again, sms for inquiry about post, postage price based on location, 0401689894

Edited by Gothik33

I'll take the O2 sensor.

Brisbane 4073

PM me with the best way to pay you.

Cheers

SImon

ANNUAL BUMP :domokun: :domokun: :domokun:

JUST BACK FROM OVERSEAS AND FOLLOWING ITEMS ARE STILL LEFT

4 RB25 manual series 2 ECU, will run S1 also - $50

7 CAS for rb25, again didnt know i had it, comes with bracket, unknown condition - $75

8 RB25 Hydraulic lifters, set of 24, all good condition,

have sat in oil bath for close to 2 years.

didnt make noise when taken out of head - $50

10 Rb30 crank - has been micropolished, kept this one as a spare in case mine

shit itself, hasnt happened yet, wont need it. $100

13 KKR style turbo HOUSINGS. front rear and CHRA. no shaft or blades.

bought as spare, never needed, sold turbo, buyer didnt want spares.

Comes with V band adapter. $100 for all of them $50

16 2 x Genuine Greddy Airinx air filters. 80mm intake diameter, never used. got wrong colour,

never returned as i bought from USA.both for $170 or $90 each $150 both, $75 each

17 RB25 O2 sensor. dont use it anymore. $20 $15

again, sms for inquiry about post, postage price based on location, 0401689894

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi from Canada, Both of my calipers are starting to fail. My car is a 2005 M35 Stagea ARX and I can't seem to find any parts or any cross reference caliper that would fit my car. Is there a company or a similar caliper that would fit and I could replace the OEM one. Or if anyone knows where I can find a new OEM. Any help is very appreciated. Let me know!
    • Maf is a question mark but TPS  I have set at 0.47, the fact that I’m getting proper voltage range out of it with the key on leads me to believe it’s functioning properly. I’m getting proper voltages on basically everything. I still need to look up voltage ranges for z32 maf and test that 
    • Honestly no not at all, but it’s a very basic tune, it’s stock injectors q45 tps and z32 maf. Other than that it’s a completely stock base map. The file is from nistune and from my understanding if it was tune related I would be able to unplug maf and tps and it would still start even if it was a really shitty start. I have tried starting it with coolant temp, maf, and tps unplugged none of those 3 togethor or individually changes anything 
    • 🏆 Skyline Supremacy Meets Mount Panorama Magic 🏆 Join SAU NSW as we take the long way to Bathurst, the home of GTR greatness. Saturday 30th August 2025 7:00AM Meeting Hanna Park North Richmond 7:30AM Departure Cruise Via Bells of Line Road 9:00AM Arrival to Stop 1: Golden Poplars Meadow Flat 9:45AM Arrival to Final Destination: Mount Panorama Motor Racing Circuit Meet Location: Hanna Park North Richmond Stop 1: Golden Poplars Meadow Flat Final Destination: Mount Panorama Motor Racing Circuit   *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • What does it look like with highway driving? And yes, I had a similar thought as Duncan. It looks quite similar in my Stagea and I have made myself accept it as normal. Might have to look into it some day   Highway gets as low as 10l/100km on my end so I'm not as worried about it being a mechanical issue. More likely just the tune on the haltech.
×
×
  • Create New...