Jump to content
SAU Community

Recommended Posts

i need to get some new wheels as i have 2 bent rims thanks to a pothole so im just after some opinions

now if i had the money id get a set of volk gtc in gold but the budget wont strech that farpost-47504-1282451608_thumb.jpg

Edited by turbosuk
Link to comment
https://www.sau.com.au/forums/topic/333804-opinion-needed/
Share on other sites

may i ask whats the budget range you'll be looking at? there are a few shoes out there that will look really hot on on the V, but depending on $. My gtcs were close to $7k with tyres, formulas etc. but at the end of the day im extremely happy.

buy what you'll be happy with and in your budget, aus made, us made etc is fine. but if you are going to track it stick to forged japs only.

Link to comment
https://www.sau.com.au/forums/topic/333804-opinion-needed/#findComment-5410420
Share on other sites

mark,

given where you live I would say whatever wheel you use you have a bit of rubber on it. that said I like the silver ones.

yeah the roads are allright here i think i did on the coffs road between ebor and coffs the road is shit

so i think ill save some coin and go the new rota wheels 19x9+20 front and 19x10+20 rear

Link to comment
https://www.sau.com.au/forums/topic/333804-opinion-needed/#findComment-5412203
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...