Jump to content
SAU Community

Recommended Posts

HEY EVERYONE!!

i HAVE 2 RB20DET ENGINE PARTS LAYING EVERYWHERE! ONE HAS STUFFED BEARINGS AND THE OTHER HAS A CYLINDER SEIZED BUT PARTS ON TOP ARE STILL VERY USEFUL... NO TURBOS ON THEM...

JUST LET ME KNOW WHAT YOU WANT AND MAKE ME OFFER... BOTH MOTORS ARE 4WD

PM ME OR TEXT ME 0411487835

CHEERS

Link to comment
https://www.sau.com.au/forums/topic/335425-rb20det-engine-part-out/
Share on other sites

OKAY GUYS,

I HAVE THE FOLLOWING:

X1 CRANK ANGLE SENSOR: $150

X1 ALTERNATOR: $150

X2 RB20 COMPLETE PLENUM WITH FUEL RAIL AND INJECTORS: $200 FOR ONE SET

X2 PAIR OF CRANKSHAFT COVERS: $50 FOR ONE PAIR

I'M SURE THERE IS A FEW MORE HERE JUST LET ME KNOW

BUMP

Need this stuff gone everyone, My car is going to the mechanics on monday... so some of the parts won't be avaliable to you at that time...

BUMP

Need this stuff gone everyone, My car is going to the mechanics on monday... so some of the parts won't be avaliable to you at that time...

hey mate i brought the coilpacks off you do you have a AFM by any chance?

Hey there, did u happen to have another AAC valve and coldstart air valve?

I'll have a look for one today if i can... Haven't really had the chance

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...