Jump to content
SAU Community

How To Take Off The Rubber/plastic Seal Around The Outside Of The Doors And Glass


Recommended Posts

on the side of the car( coupe) how do you take off all that plastic as i want to clean it up spray it and also check for rust and polish the bits that u can see but cant get to.

any info cheers guys

which glass?

anyway -

front/rear screen : cant do anything without pulling the windows

rear 1/4 windows : cant do anything without pulling the windows

outside of door window seal: one screw at the back of the door, easier to remove with the mirrors off from memory

inside window rubbers : remove the garnish between door jam and rear 1/4, then just pop the little plugs out and remove

inside door: pop the plugs at each end then stretch the rubber over the pointy studs that are stuck into the door

So if you wanted to take your car into a windscreen mob, is it an easy job to replace the rear window rubber seals with new ones? My front one is new and looks great but it makes the rear one look like crap.

Edited by PM-R33
So if you wanted to take your car into a windscreen mob, is it an easy job to replace the rear window rubber seals with new ones?

easy yes (i used BA falcon generic rubber) - but obriens etc dont cover your screen - so if they break it, you gotta pay for a new one

Well that sucks. I'm guessing it's the same deal with the side ones? My car had the weather shields on it when I bought it and when I took them off it made a lot of damage on the rubber, pisses me off every time I look at it (for 5 years now lol).

Edited by PM-R33

cheers for replys

just the side windows on the door and just behind it i figured id spray paint the plastic. also theres a leak, leakinginto/ onto the back seat nothing major just dont know whether to just use some sealer or take it off and put some rubber on

ne ideas how to bring the plastic back to life??

un related, how hard is it to take off the front side guard?? just screws or more

cheers again

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • 21 is explicitly the coils detected as the issue. Is it guaranteed the actual issue? No. Just the ECU thinks it is. When you say rattling, describe it better, get an audio clip as best you can if possible.
    • Yea got me coppers. Bad news is I just put them in and the car still has the light and shakes. I also noticed I hear like rattling coming from the exhaust piping right under me. Does 21 also have a possibility of being O2 sensors?   So, coil packs are good, the harness is good, the MAF is working, and obviously the spark plugs just replaced and working.
    • Make sure you drop the GTT base tune back in, and set your injectors again, this will remove anything playing up with it you may have removed. Possibly lean there as it's normally a fast transient going THROUGH atmospheric pressure, and a turbo motor would then quickly go richer as boost builds. The only worry you MIGHT have is ignition timing, as the DE is higher compression than the DET from memory. But again, you're not in boost, so the DE motor will be a lot more forgiving at atmospheric.   Get Murray, Kinkstahs, and Johnny's input on tuning haltechs, those guys have played with tuning enough in the past to be able to help now you're past the trouble shooting stage of the MAP issue
    • @Rusty NutshI mate. Do you have a pinout diagram for the na neo auto ecu? 
    • Yeah thats the plan now. 🤞
×
×
  • Create New...