Jump to content
SAU Community

Recommended Posts

1996 R33 GTST - Series 2

The engine has been rebuilt in the past two months due to new turbo (ATR43). New engine has only done about 2000 kms.

The engine has forged ARIAS pistons, metal head gasket, all brand new belts including timing belt and new water pump.

The new turbo has done around 5000kms.

The car also has the following:

#All four Tein Suspension

#Genuine HKS intercooler

#K&N Pod Filter

#GReddy Profec B-Spec2 Boost Controller

#APEXi Power FC & Hand Controller

#3inch turbo back exhaust which goes into a 3inch high flow cat and that goes into a 3 1/2 inch genuine HKS super dragger

#Turbo smart blow off valve

# ATR43 TURBO

#Remote start/window lift kit

The car is pushing on low boost 200rwkw. On high boost it is pushing 260rwkw. I have the dyno charts for the car.

Things for road worthy - if brought without out one.

#Remove pod filter and replace with standard airbox

#Remove blowoff value and replace with standard

#unplug the hand controller from the power FC

IMGP2889.jpg

IMGP2890.jpg

IMGP2891.jpg

IMGP2892.jpg

IMGP2894.jpg

IMGP2896.jpg

IMGP2897.jpg

Picture017.jpg

Picture018.jpg

Picture036.jpg

Picture037.jpg

Car in excellant condition. I currently have a company car and have not drive the skyline as much as i would have liked.

about $13,000.00 has been spent on the car in the last 2 years. all work that has been done has reciepts and will provided to buyer.

$17,000.00 ono $15,000.00 with no road worthy cert

Contact: Koosh - 0409 408 990

Link to comment
https://www.sau.com.au/forums/topic/340110-1996-r33-gtst-series-2/
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If you mean the alarm immobiliser; theyre internal to the alarm itself which makes that difficult; I couldnt even see where he put it; its not in the same place as last time; but with all black wiring it might be very challenging to trace  I had someone turn the key for me as I know it only primes for a couple of seconds As my post above; I am getting no voltage to the pump at all; but I am testing continuity of the power line (SB) from the pump plug to the relay fine. As well as the negative from the pump plug to a 12V constant.    Yeah; he blammed the no start on a bad battery; said I needed to get a new battery and it'll start. Turns out the battery drained because the tail lights had been on for half the day during the install (the rubber cushion on the brake switch gave out while he was testing it as I have a picture of the car from that morning with the tail lights off..i've replaced that). The battery was turning over the engine just fine for a long time; but got low since lights were draining it so it was too low to test a start after he finished. I bought a new one on his advice...$250 wasted. My original battery charged up just fine and is healthy.    It was running perfectly fine when I messed up the old alarm (programmed out the remotes). He couldnt start it after removing the old alarm; my assumption is that when he unhooked it; he didnt bridge the circuit back when trying to start it. Its always been perfectly fine. The ECU swap and pump were 2 years ago. It's never missed a beat in that time. 
    • This is a big issue for me without the diff. I just have zero drive from the passenger side when drivers side has no traction. Bec's parents place has a crazy steep driveway with odd camber and I have never been able to get up. My bro-in-law's 130i with an (unknown brand) LSD gets up fine as does their dad's Hiace. My car stays at the bottom. We have other odd camber roads around here as we're elevated a bit and if it's raining I can get totally stuck around some hairpins. 
    • Yeah, I am super excited for this.
    • Was the car running before he touched the car?
×
×
  • Create New...