Jump to content
SAU Community

Recommended Posts

I am selling my stagea ppls. why?? coz i want to buy another 4x4 of the off road kind.

Anyway heres the details

2002 Nissan Stagea (M35 250t rs)

50 000kms

rego till march

MODS

Kakimoto cat-back exhaust

DBA 4000 x-drilled and slotted front rotors

RDA slotted rear rotors

QFM A1RM pads on the front

QFM HPX pads on the rear

(brake discs and rotors only 10 000kms old)

Pioneer head unit and rear speakers

Other info:

-the car is fitted with the factory aero kit without fog lights in front bar.

-Replaced the spark plugs with DENSO iridiums 3000kms ago

-changed leaky left bank rocker cover seal (common prob with the M35)

-replaced CV boot right hand side outer (had others checked all seem fine)

-always change the oil and filter every 5000kms with Penrite full synth.

-have 8lt of nissan matic J trans fluid to come with sale (i havent got round to changing the trans fluid yet)

-factory Bilstein suspension

-the car runs very smothly never had one problem with it gets 750kms off a tank on the freeway. (little bargining info to convince the better half :thumbsup: ) paint is in perfect condition apart from the little stone chip here and there. interior is immaculate except from the front speaker pods (me thinks previous owner had custom door pods but didnt want to sell them so replaced with this crapy stick on carbon fibre look alike material. not that bad you can always source some factory ones)

car looks the goods and will not disapoint.

Matt 0422806886 (ring after 5pm mon-fri or txt within these hours due to working)

[email protected]

I am looking for 17000

heres a couple of pics

post-75023-0-81693100-1295342136_thumb.jpg

post-75023-0-36994200-1295342147_thumb.jpg

post-75023-0-21886800-1295342160_thumb.jpg

post-75023-0-31238400-1295342176_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/350868-2002-nm35-stagea-for-sale/
Share on other sites

  • 6 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...