Car Wont Start-Emanage Blue

[s13kris]

Hope im posting in the right section...

Installed an emanage Blue today into my car (R33 s1) using the specific harness so i couldnt make any mistakes. set all jumpers correctly according to the manual and all the dials to "0". tried to start the car and it wouldnt turn over. tried again and same thing. removed harness and went back to stock ecu only and car turns over now but is running rough..... any ideas? anyone had the same problem?

i quickly checked my coilpacks and found 1 & 4 possibly not working.. ie. when i remove the plug off either of them car still runs the same.

Could this be the issue? and why would it not run with emanage but will run with stock ecu?

ALSO i noticed on the specific harness it had a 2pin plug which i cant plug in anywhere on the emanage and also a red and a black wire with female connectors im guessing these are for further accesories??

ive already done a search and only found useful info on it burning coilpacks with older versions but i may have missed something so if someone can point me in the right direction.

Kris

[DVS JEZ]

Red and black??? Power and earth maybe. U should search for the pin outs for the emanage to see what they are

[s13kris]

all sorted!! for future refrence used the suport tool to check settings and found that it was wrong afm settings. standard RB25 S1 afm is NS_HW-3 i believe series 2 is diffrent. still unsure as to why car wasnt running correctly without the emanage

and i believe the red and black female connectors maybe to power boost pressure sensor???

[scotty nm35]

It sounds like you fouled the plugs.

On the Ultimate the pressure sensor plugs into the front panel, not sure with the blue though.