Jump to content
SAU Community

Recommended Posts

Hey all so i've decided to sell my beloved skyline "32SXC".

So here's the specs:-

Engine (Tuned to 306rwhp with dyno sheet for proof)

- S2 r33 Rb25det

- Apexi 400hp BB turbo (See's fullboost of 16psi @3500-3800)

- HKS FMIC

- Trust Turbo Back 3" Exhast w 2 HiFlo Mufflers

- Splitfire Coilpacks

- Bosch 040 Intank Fuelpump

- z32 AFM

- Grex Oil Cooler

- Greddy Radiator

- Carbon Fiber Coil Cover

- Homemade Cold air diverter And heat shield on pod

Drivetrain

- 5 Speed manual from s2 r33

- Twin Plate Brass Button Clutch

- Recently Shimmed Vicious LSD

Suspension & Handling

- Tien HA Coilovers (Height&Dampner Adj.)

- JJ Camber Adjuatable Front Control Arms

- Cusco Front+Rear Strut Braces

- Nismo Toe Rods

- GTR Brakes w/ DBA Slotted Rotors

- Rays 17x9, 17x10 Wheels (Black)

Electronics

- Rb20 ECU (good for nistune)(also car was tuned in Japan so im sure a good nistune would reap many more kw's)

- Blitz Dual Stage SBC and Turbo Timer

- GlowShift 7color gauges - Oil temp

- Oil pressure

- Water temp

- Boost (all gauges can be 7 different backlights + paterns etc)

- Sony Head Unit (groove or somethin)

- Kenwood 200W Amp

- Sony 1000W Subwoofer

Interior

- 20% trans Black Window Tint

- Red Leather Handbrake & Shift Boots

- R33 Seats with Black/Silver Leather fitted covers

Exterior

- Maroon Paint (Metalic)

- Uras Front Bar (has bit of a crack from my driveway)

- 32SXC Plates (black with white letters)

- Freeworks, ilovedrift, nissansilvia.com stickers

Im looking for $10,000 ONO, or a swap for a small 4wd (ideally Jeep Wrangler?, or Suzuki Vitara)

Contact Simon by text on 0402 547 310

Im located at Stretton, QLD (southside brisbane)

image3gvs.jpg

Uploaded with ImageShack.us

image4ze.jpg

Uploaded with ImageShack.us

photo1qz.jpg

Uploaded with ImageShack.us

photo3sr.jpg

Uploaded with ImageShack.us

photo4gr.jpg

Uploaded with ImageShack.us

Link to comment
https://www.sau.com.au/forums/topic/359837-r32-rb25det-306rwhp-32sxc/
Share on other sites

when you say open to swaps what you after as if your after a tt supra plus 14k my way (its got 300rwkw and 836nm) and 6 speed :worship:

haha cheers man would love too but i need more dollars haha

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
    • yeh they are 235/45/17 up front and 255/40/17 in the rears. I still didn't get my answer if i can fit a 18x9 up front. I want to get 4 of this and see if they will fit before committing as they didn't see an 18x8 as an option but there is a 18x9.5 also.   Enkei RS05-RR 18x9 35mm ET 5x114.3 75.0 Bore Matte Gunmetal Wheel
×
×
  • Create New...