Jump to content
SAU Community

Recommended Posts

bit more complicated then that.. it has been tried.. anything from japan is gonna be costly.. thats where matty is based.. and i can see smaoked reverse lights causing a defect issue..

$180 for front indicators to be tinted , aswell as a $1000 for tail lights? thats a terible amount of money to be spending on cosmetics. seriously just buy some black acrylic and also some clear. mix it to a ratio that you are happy with and just spray them your self. i did mine , definitly makes the car look more stealthy , as long as its a black car. why spend all that money ?

my 2 cents, cheers

na outside man , not inside lol. that wont work at all . outside is the visual you want to see , you arent going to be looking at whats inside. thats an alternative , those night shades.

but be careful because iv seen people use night shade on their cars , they are more of cheap look . looks kinds crappy in my opinion. thats why iv used black and clear , seams to look much better than that crap.. bare in my mind iv got a spray gun/compressor to do all that.

good luck.

Edited by sky017

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I hadn't thought about the variable power steering assist. Presumably, it will always be the same level of assist as you get in an S14. The R32/3/4 are either helliishly heavy (at low speeds) if the solenoid is not powered at all, or hellishly too light (at high speed) if it is powered all the time. I presume that it is PWM controlled on those cars. I hadn't thought about the S cars not having variable assist. ugh. What crappy plebby cars they must be!  
    • Hmm yeah that is a good point. It looks like it'll just bolt in with no real issue besides maybe the bushings being different. My other concern was that 2 pin plug that I assume is used in some way to control the rack solenoid depending on the speed signal from the ecu. The DMAX rack doesn't even have that plug though so, don't think it'll matter. Might just order the rack and see how it goes. Will update this when I figure something out
    • I'd say it's a fair bet that the feed and return fluid lines will be in different enough spots that you would need to come up with a way to cut the originals short and adapt with new hard line adaption or braided teflon hoses or somesuch. But really, you have the car, you have the photos of the DMAX rack - you should be able to go out there and see for yourself whether they're in the same or different spots.
    • I've been doing some looking around and honestly was just considering throwing a new rack at it. I saw that the dmax silvia rack bolts up into the 33 with the silvia bushings but not sure if the high pressure lines will sit in the correct spot. I believe other version of the 33 rack are the same/similar to the racks that can be opened up without as much fuss so I assume the dmax rack would fit but any ideas?
    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
×
×
  • Create New...