Jump to content
SAU Community

Recommended Posts

Hey Guys, selling the Power FC setup that was used with my big Z32 motor.

  • Replaces AFM with MAP sensors
  • Allows 20x20 mapping
  • Currently tuned for Nismo 740 injectors

All sensors, wiring harness and plugs are (included as pictured below) ready to fit.

ecua.jpg

plugsp.jpg

The hand controller can be used for tuning, and also displays the following

InjDuty - Injector Duty / How busy the injectors are

IgnTmng - Ignition Timing - Camshaft timing

AirFlow - Airflow meter voltage

PimVolt - Map Sensor voltage

Eng Rev - Engine revs

Speed - Road speed

Boost - Boost Pressure (requires optional boost kit fitted)

Knock - Knock sensor reading

WtrTemp - Water temperature or engine temperature

AirTemp - Air inlet temperature

BatVolt - Battery voltage

The hand controller also records maximum readings, so you can review max water temps/injector cycle/air inlet temps/knock numbers etc after a drive. I have found this feature particularly useful.

Also included in the sale is a Greddy multi switching unit. This was used to run the VTC on my VG30DETT, and the second output was used to run a thermofan. The Greddy is a two channel arming switch that can operate on anything from one to three paramters via the factory ECU or via external sensors. It can also function as an alarm/warning unit. This would suit someone wanting to run thermo fans, water/meth injection, nitrous, whatever...

greddy.jpg

Price: $1800 the lot, including freight, or best offer

Location: Sydney (North)

Condition: As New

sell power fc seperately? msg me on 0423 441 677

Hi, yes I would consider separating -hit me up with an offer.

????????

Just wrote back to your PM.

Considering the standard power FC's seem to go for around $1200 I'm not keen on letting the D-Jetro go for $1100... but thanks for the offer.

  • 2 weeks later...

A change of plans means asking price down to $1200 THE LOT. Sell the Greddy and make some money back...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Welcome!  Car sounds great, anypics ?
    • Welcome.  800hp should be a bit of weekend fun!
    • I'm going with "Just run two gates". Fix the problem conclusively. It's the only way you'd ever truly know, right?. This is all pretty much splitting hairs. Even the extreme example where it takes two whole seconds at 100kmh or something sounds monstrously dubious. And anyway, when you're punching the throttle when you 'need' this power, you aren't at 2800rpm in the wrong gear. Test it at 5600rpm in 3rd gear, when you're traction limited punching out of a sweeper. Much difference there when you account for traction?
    • And the full R32 GTR wiring diagrams are also freely available. Hmm.... there's supposed to be an auto replace that would have linked the thread. Here it is, manually  
    • Ahh...should have been clearer ~ there's 2 ... SMJ = super multi junction (connector)...   ...this is connector 6 & 25 in above image -- body harness to engine loom (6) & body harness to main loom (25) Headlights go to front via connector 6 ; fuel gauge goes to tank sender via connector 25  ...like I say this is R33 diagrams, but at a pinch R34 won't be too far different. *IF* the two ground faults are related, this can be the only place where both wires converge (as one runs to the back, the other to the front)... ....thing is, you probably need to establish if the faults are related (unless you examine that area and find obvious chaffing on the looms there to body ground)....*IF* the fuel gauge is still broken (full needle deflection), I'd be headed for the boot, remove fuel sender wire, key on and measure the voltage there ~ it should be roughly 10volts. If that's ok, check sender to ground resistance...if this is a dead short to ground (and there's fuel in it), then sender has failed or something funky has happened to wiring in the tank. edit: ahh...rereading the thread, this is R32....above fuel sender test still valid tho'
×
×
  • Create New...