Jump to content
SAU Community

Recommended Posts

Trust TD06H-25G: Rebuilt in sep 2010 by GCG.

Manifold for RB25DET

Intake pipe

External wastegate (greddy)

Have a whole new engine and no use for this anymore.

Originally cost me $4k, rebuild alone cost $1480.

Whole lot for $2200

Turbo only for $1900

For the other items, I will only sell seperately if the turbo is sold first.

Located in Bundoora, Melbourne.

Pick up preffered, but can organise shipping at buyers cost.

Cash on pick up or paypal.

[email protected]

0431874557

post-6012-0-77979100-1318195509_thumb.jpg

post-6012-0-50381800-1318195528_thumb.jpg

post-6012-0-68757200-1318195541_thumb.jpg

post-6012-0-45629100-1318195587_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/379568-trust-td06h-25g/
Share on other sites

Before rebuild it was running almost 2 bar. I don't have a hp figure though, never got around to getting it dyno'd. After rebuild, it was used on the car for a couple of days only, running 1 bar boost, for about 50km. Engine was on the way out and was cheaper to replace than rebuild.

Link to comment
https://www.sau.com.au/forums/topic/379568-trust-td06h-25g/#findComment-6053571
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...