Jump to content
SAU Community

Recommended Posts

this saturday (3rd dec) the westcoast jetsprint club will be hosting the eastwest showdown

some of the best drivers from the east coast will be making the treck over to take on the local teams

check the website for details www.jetsprintwa.com.au or our facebook page WEST COAST JETSPRINT CLUB inc

should be a great day of high class racing

GWP

oh and dont forget to cheer for firm racing ( under suspicion and prime suspect)

Link to comment
https://www.sau.com.au/forums/topic/384404-westcoast-jetprint-special-round/
Share on other sites

was a great day with a huge turnout specially since we were competing with the drags

our boats did well with my driver and i getting the hang of the faster ride and different handling and our b team getting a podium finish

the other boat was right up there till the engine pretty much let go but they had qualified for finals so putted a lap to get themselves a podium as well

there was an unusual large number of crashes and engine damage including the complete wrecking of one of the group a boats (brand new too)

but other than a bit of bruising and a concusion nobody was hurt

its looking like its going to be a huge season we start again on the 14th of january

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Let large companies that are making money off selling kits do the preliminary engineering for you. If they all do -10, then that is all you'll ever need. 
    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
×
×
  • Create New...