Jump to content
SAU Community

Recommended Posts

Hi guys,

Up for sale is my aftermarket exhaust system off my old R34. The car was written off and the new R34 I bought already had an aftermarket system on it. So this is up for sale. It has been garaged for about 5 months but finally needs to go.

ITEM: 3.5" Front/ Dump pipe with oxy sensor. Cat included. 3" catback with muffler and cannon.

BRAND: X-Force

MATERIAL: Stainless Steel

REASON FOR SALE: As above

CONDITION: Very good. Slight surface wear

AGE: Roughly 2 Years old

KM's TRAVELLED: 15,000km give or take.

ORIGINAL PRICE: $1100

PRICE: $600- negotiable

CONTACT: Tom- 0418 54 55 27 or email [email protected]

Pick up only from BRIGHTON EAST, Victoria thanks.

SMS during business hours, or call after hours.

post-33678-0-77946600-1329183237_thumb.jpg

post-33678-0-37619600-1329183245_thumb.jpg

post-33678-0-38745500-1329183254_thumb.jpg

post-33678-0-56289800-1329183262_thumb.jpg

post-33678-0-20355500-1329183270_thumb.jpg

Edited by tom_v
Link to comment
https://www.sau.com.au/forums/topic/391676-r34-gtt-x-force-full-exhaust/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...