Jump to content
SAU Community

Recommended Posts

1983 DR30 Skyline RS Turbo ‘Ironmask’

2.0l FJ20ET

5 Speed manual

New Daiken clutch

Midnight Purple

Jenesis Front spoiler extension

15 x 6.5 SSR Formula Mesh Alloys

Cusco Adjustable Camber Tops

Cusco Adjustable Front Strut Brace

Lowered suspension

Hi-flowed FJ20 Turbo (T3)

3” Kakimoto Exhaust (Dump pipe back)

Front mounted intercooler

GREX Oil Cooler with remote oil filter

VL Turbo Fuel Pump

GReddy ‘PRofec A’ Electronic Boost Controller

GReddy Turbo Timer

GReddy Adjustable Pressure Relief Valve

PROF Sheepdog Adjustable Blow-off valve

Pod Filter

Mines Ecu

Kenwood CD/Tuner/Tape

Bride Fixed Race Seat

Half Cage

Pivot Shift Light

Ultra Speed meter

Trial ash tray (best mod)

GReddy 60mm Electronic Boost Gauge (2.0bar)

OMORi 45mm Oil Pressure Gauge

OMORi 45mm Water Temperature Gauge

OMORi 45mm Oil Temperature Gauge

OMORi 60mm Exhaust gauge

Spares:

-R200 LSD

-FJ20 Turbo/Exhaust manifold/dump pipe

-Inlet manifold/throttle body/fuel rail

-Standard FJ20 ECU

Just had low km FJ20 fitted, with compression report.

Will require ADR compliance and rego

$8500

[email protected]

Link to comment
https://www.sau.com.au/forums/topic/39914-fs-purple-dr30-rs/
Share on other sites

Bump!

I have personally seen and driven benny's DR30 on numerous occasions since he imported it....A very unique car, it really looks fantastic in the midnight purple -

the pics don't do it justice though, here's some better ones. :)

good luck with the sale benny!

Link to comment
https://www.sau.com.au/forums/topic/39914-fs-purple-dr30-rs/#findComment-822391
Share on other sites

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Have you flushed the initial fluid yet? It should look like a rainbow unicorn shat glitter into it. 2nd or 3rd fluid change is when you party.
    • all brand new unit from Tomei, fluid, bearings, etc. Tomei said they call it a 1.5 lsd because its 100 percent lock up under acceleration and 50 percent under deacceleration.  as I mentioned I used their fluid, install and their break-in procedure, (alot of figure 8's) but even when driving straight, or even slowly backing out of garage for first time, (at 2 mph) then driving to and from figure 8 parking lot, each tire in the rear would sporadically grab, skip, bounce, shutter and skip, shutter back a force I could feel causing clutch to slip then grab, at any speed. shaking entire car. I removed unit, since I put stock back in and all is fine, via process of elimination, its something with the lsd unit itself. I wasn't going to beat up the entire car more or change anything else for no reason as I had a feeling something in the lsd itself was wrong as everything was fine before this alone was installed and I rechecked over everything else after first time backing out I suspected an issue. I'll probably sadly already need new tires now just from trying to drive it 5 miles and performing the figure 8 break in. but if someone has any ideas I'm all ears 
    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
×
×
  • Create New...