Jump to content
SAU Community

Recommended Posts

R32 interior sale

Passenger door card 20

L and R a piller trims 5 each

Bottom door trim with skyline on it L and R 5 each

Boot trim L and R side and boot carpet 10 each

Rear trim L and R 10 each

Climate control unit missing a button 15

Roof of glove box 5

Glove box 20

Metal bit that glove box hinges off 5

Bottom drivers dash bit 10 dash fuse box flap 5

Air induction thing under head light 10

Rear window bottom trim 5

Wiper arm with new wiper 10

Passenger door seal 10

Center dash surround 10

Chrome monza pod filter cover will make u win auto salon or apperntly pass a roady 1 dollar

L and R kick panel 10 each

Handbrake cover little worn no rips 5

6 bolt half shafts 10 each

Cover between glove box and passenger door 10 

Centre air vent 20

33 centre console, may fit 32? 25

33 rear seat will fit 32 10 top 10 bottom

Manual tyre changer missing tyre lever 20

0430505810 DO NOT TXT phones cut off u will not get a reply, located emerald or montrose during business hours

Link to comment
https://www.sau.com.au/forums/topic/399937-r32-interior-bits/
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...