Jump to content
SAU Community

Cheap Rb26 Running Condition $1750!

adam Foster
 Share

Recommended Posts

adam Foster Mentor

adam Foster

Posted
Posted

Rb26 engine.

I took the head off and had a triple layer head gasket put on there was an oil restricted in the head already.

Early 89 32 block so stronger. Unsure what crank but has an older n1 oil pump on it older n1 pumps are strong the new ones are made from a softer metal.

Comes with inlet manifold rail injectors etc.

Put ur turbo set up on and away u go

Was going to go in my car but have pulled out on my plans.

Sump and diff included.

1750 not neg located morisset contact 0411672105

Link to comment
https://www.sau.com.au/forums/topic/400427-cheap-rb26-running-condition-1750/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • TurboTapin
      CD009 RB Conversion

      By TurboTapin · Posted

      New or used transmission? Alignment will be the same with engine running or not. If new, i'm presuming it's a clutch release bearing size issue. If used, are you certain it's a CD009/A and not an older CD008 or less? They had known synchro issues. In my opinion, these transmissions should always be purchased new, they're dirt cheap and you avoid dealing with old revisions. 
    • soviet_merlin
      The Evolution Of "night Fury"

      By soviet_merlin · Posted

      I like your thinking! Looking forward to see how it turns out.
    • MBS206
      How can I remove this adhesive?

      By MBS206 · Posted

      You've got yourself a good old game of have fun. That shit is annoying as hell to remove. Thankfully for you, yours is on metal, most of the stuff I take it off is plastic, so typically hear guns are out. I normally end up continually dragging my thumb with pressure over it to get it to peel up. Eucalyptus oil then works well for getting residue and last remnants off.   Edit: plastic scraper might be worth while too. One that'll dig into the foam tape, but not scratch the paint.
    • jez NF
      The Evolution Of "night Fury"

      By jez NF · Posted

      So I ride and race motorcycles for fun and have always used a van to transport my track weapons. Figured towing a racebike with a skyline would be different and if done right could - "look fully sik" or quite cool for us grown ups lol. Pic of yours truly on two wheels I also have a trailer already kitted out to transport my bikes ...and I have a spare set of rims that match the car that I was going to rebarrel to get deeper dish at some stage but they have just been gathering dust. Sooooooo it is only logical.... Stay tuned !!    
    • GTSBoy
      How can I remove this adhesive?

      By GTSBoy · Posted

      If by "flap disc" you meant "chocolate wheel".... then they are OK for getting off stubborn remnants. But not for stuff with bulk depth. If by "flap disc" you meant "abrasive paint f**ker"....
×
×
  • Create New...