Jump to content
SAU Community

Recommended Posts

I have R33 1996 GTST series 2 my passenger side central locking and power window both malfunction. I tried the switches from the driver side and it doesn't do anythings at all. I checked the fuse for power window at the front it is intact. What can cause this issue? is there a fuse for just the left hand side door? By the way the right hand side working fine both window and lock working properly.

Usually it has to do with the power window amplifier in the door that fails to operate. If its broken then youur cannot operate the window. if you have mates with a 33 see if you can borrow one to test.

Not 100% sure on 33s, but im going off my c33 laurel, most jap stuff is the same.

Does the window go up with the passenger side control?

Generally central locking is controlled by the master unit. But in saying that, if the master unit is broken, you should still be able to power the window with the passenger side.

Is the window up at the moment or stuck in the down position?

Hi man, ive got a R34 GTT so might be a little different but i had to replace the passangers side speaker the door card is pretty easy to get off just a few screws and then lift it up, the window power unit is just a little box attached to the door card one of the wires might have come loose or even got water damaged, maybe pull the door card and have a look.

goodluck Brent

The window stayed up not moving, no clicking sound and the central lock just dead and no clicking sound at all

Sounds like a dead/water damaged amp or lose plug/wire.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...