Jump to content
SAU Community

Rb26 Cam Covers + Valley Cover

R32 Driver
 Share

Recommended Posts

R32 Driver Mentor

R32 Driver

Posted
Posted

Hey guys,

I have a set of RB26 Cam Covers + Valley Cover for sale.

Its painted blue however It can use a new coat of paint or a clean up

Asking $300 ono

Located in Perth

Cheers

Steve

Link to comment
https://www.sau.com.au/forums/topic/401114-rb26-cam-covers-valley-cover/
Share on other sites
krayzie32 Mentor

krayzie32

Posted
Posted

these are a straight bolt on to 25? any idea on frieght to 5118 S.A?

RB25 Front cam belt cover would look out of whack due to different shape including backing plate...

If you have vct you would need to make provision for vct gear intake side of timing cover if you retrofitted the backing plate (involes undoing cam gears/tbelt etc) & cover of rb26 other than that, straight fit...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kinkstaah
      NC MX5

      By Kinkstaah · Posted

      I am well aware as I did rant at him to buy a MX5, buy the 2.5 before he DIY'ed it, etc as well as do things to the holden. He will obtain a ND. It's the best of both worlds. They look great in person, definitely the best looking one. Just a matter of time now.
    • r32-25t
      NC MX5

      By r32-25t · Posted

      Remember this is the same person who said he’d never own an nc 
    • zique
      Ceramic turbine damage to engine - what did yours do?

      By zique · Posted

      ouch! how is the car now?I had sold my gtr but have been looking into some on trademe and a 260RS but I wouldnt be keen on any repairs needed on them
    • MBS206
      NC MX5

      By MBS206 · Posted

      This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • MBS206
      Jacks that fit under GTR lips that can reach the subframe?

      By MBS206 · Posted

      Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
×
×
  • Create New...