Jump to content
SAU Community

Recommended Posts

hey all just bought a r34gtt the last owner took it for a wash and got the coil pack wet i let it dry out it runs fine now but some times at low oraround 4k revs when boosting it has a spitting noise from the back cold or warm dos not matter just geting old do u think i need to replace the coil or?

Link to comment
https://www.sau.com.au/forums/topic/403392-r34gtt-spitting-underload/
Share on other sites

hey stock boost i think its like 1 bar dont realy know how to read the stock 34 gauges but it gos all the way to the 1 it only has a dump pipe and no havnt cleand the meter and would that be the sensor in the pipe with the pod filter? sorry new to skylines

lolol didnt wont a auto but couldnt afford a manuel and i seem to give em more when in a manuel + gota drive to town daily so meh yer man il go over ti tmozz i think cuz they got wet yesterday prob need a good warm day to let them dry up if not new coils ant that bad first upgrade haha

http://www.justjap.com/store/search.php?mode=search&page=1

http://www.kudosmotorsports.com/catalog/advanced_search_result.php?keywords=splitfire+r34

^^^ Check these out ^^^ or Ebay.

Fitting is free cause you DIY.

Airflow meter is the tubish type thing after the pod/airfilter. Search on here to find how to clean it.

A bit of the correct spray in the right place.

First time I test drove my car, the guy had gotten water in the coils, Sounded a bit like that but was waaaaaaaaay worse. Pretty much undrivable.

I would say, Dry those suckers out real good, see if it changes anything, go from there.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
    • Just like in being 14mm too small (296mm) makes it not fit, being 14mm too big (324mm) it also won't fit. You want to find the correct rotor.
    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
    • Pretty sure it is a common fault. I believe this is the only part you need, but don't quote me as I don't have a V36.  I also believe it is a bit of a pain to change and the device needs to be encoded to the car once it is replaced, so may need someone with the right tools. Buy Genuine Nissan 48700JF00D (48700-JF00D) Lock Set-Steering. Prices, fast shipping, photos, weight - Amayama
×
×
  • Create New...