Jump to content
SAU Community

Recommended Posts

putting some bits and bobs up i have about the place not being used

will get pics up when i get a chance or text me and ill mms them thru

located northern nsw bout 30mins over the boarder

can usually meet up the coast but if needed

text preferred on 0435494669

R33 rear brake setup complete with hand blake lines etc -$300

R33 cat back 3inch straight thru into twin 3 inch pipes (not the prettiest but does the job) -$200

post-48080-0-99275100-1348481423_thumb.jpg

post-48080-0-56424500-1348481435_thumb.jpg

pretty much any R33 panels just hit me up what you need

RB20 stock turbo -$100

RB exhaust manifold with a t2 adaptor plate welded to it,with 3 inch stainless dump and front pipes to suit a sr dump flange so sr suited turbos are direct bolt on -$200

RB20 cross member -$100

RB oil cooler setup (just uses rubber hose not braided) -$150

post-48080-0-07249400-1348481410_thumb.jpg

600x300x75mm front mount used condition -$100

R33 gtr intercooler used condition -$200

R32 bonnet couple little dimples -$100

R32 lsd -$200

R32/S13 hicas lock bar -$80

R34 front gaurds

good condition in silver -$100 each

CA18 brand new stainless low mount tuned length manifold -$200

post-48080-0-65460100-1348481364_thumb.jpg

post-48080-0-07991800-1348481381_thumb.jpg

SR20 stainless bellmouth dump and frontpipe -$200

(best SR dump ive ever seen icon_e_wink.gif)

post-48080-0-67200300-1348481449_thumb.jpg

post-48080-0-56556400-1348481466_thumb.jpg

S14 APEXI 3inch cat back with muffler and canon (very good condition apart from couple scraps on the muffler)-$300

GT35R-just a china .70 front 1.06 rear, water and oil cooled only been on car 100ks

still on car atm if anyone wants to see it run ive just decided to go a smaller turbo -$300

post-48080-0-55175500-1348481348_thumb.jpg

gizzmo electronic boost controller -$200

post-48080-0-61017300-1348481327_thumb.jpg

autometer 5inch tacho with shift light silver face -$100

post-48080-0-98291700-1348481304_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/410069-bit-of-this-bit-of-that/
Share on other sites

  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Sane enough. Remove the roof liner, because the acid will go everywhere.
    • Thanks guys, I really appreciate the help and experienced opinions.  I have spent a lot of my life working on boats so I'm pretty good with fibreglass. I'll take everybody's advice in here;  I'll cut a little more of the 2nd layer away as it's a bit crunchy rust and also it's sitting high now. Then I'll wire brush it all a bit to get off anything loose, then I'll soak the bejesus out of it all in rust converter. I'll make sure to get a little hose piece and feed it into all the holes and gaps between the roof layers. Then I'll fibreglass up the holes.  Then I'll get a pallet of filler and mix it with 3 buckets of hardener and hope that is enough to build up the roof corner.  Does that sound sane? Is one type of filler better than others for this?
    • My goals for it atm are to get it registered, respray and some mild power gains eventually... I picked up the car from an elderly gentleman near the border of NSW and VIC, its honestly a bit rough and looks like its been driven on a farm (because there was so much dirt underneath). Last week I dropped the subframe and emptied the old fuel out + added a new fuel pump (think the old one went bad from old fuel). Now I'm onto fixing a coolant leak at the rear of the engine + adding a new radiator as the old one is corroded. After that i have a new bumper, coils (as the old were leaking) and lots more
    • Welcome buddy! Plenty on here and YouTube. What are your plans for it? Good luck with the Rwc and Rego bud!
    • Love this so much! Please post a photo when you have a bike on the trailer.  I was a little bit worried about having a tow bar on the Skyline, but having it hidden behind the number plate is genius
×
×
  • Create New...