Jump to content
SAU Community

Recommended Posts

Think it's time to move on and prioritise a bit. Up for sale is my 91 model a31 cefiro. Have spent bullshit amount of time and money on this thing in the last 2 years (with receipts). I wont be letting this go for a low offer or if you seen like a dick. It was originally a rb20e non-turbo. I brought it painted, with coil overs and a stock rb25det motor and gearbox about 2 years ago. Car is mod-plated for engine and gearbox. All low ball offers or swaps will be ignored. Car is very clean for its age and draws no un-wanted attention. If you have any questions feel free to PM me. I have a shitload of receipts for this thing (15g+). The price is high but there is absolutely nothing left to do on this car, get in and drive! If you can find a better, cleaner and more reliable cefiro I suggest you buy it. If it doesnt sell Im not to worried. I may swap but ONLY for a ute and some cash. Can remove parts to make cheaper. You dont get to drive unless you put down a deposit, Im happy for all inspections and I don't mind ME driving. As stated, Price reflects how much I love this car and the time and money has been poured into. Has 6months rego. Car can be seen at matsuri.

Price: offers over 13g 6months Rego, RWC, and all spares I have.

Engine

325hp on 10 psi - 395hp on 16psi...VERY responsive setup. Have dyno sheets. Plenty left in it, tuned for fun/useable power rather then peak power

3076r .63 rear

x-force stainless highmount manifold

45mm Turbosmart hyper gate (18psi spring)

Cometic 3layer metal head gasket

ARP head studs

Every seal, gasket and belt above the block has been replaced less then 2000K's ago (half-seals, timing belt, all intake plenum seals, tapet covers, manifolds etc etc)

Custom water lines

Custom turbo lines

All new stainless 2.5" piping

Stainless screamer pipe

All new custom stainless 3" dump pipe

PWR power steering cooler with custom lines

Oil cooler with re-locator kit and custom lines

14" thermo fan on a switch

50mm Alloy radiator

Spitfire Coilpacks

Big front moount

Excedy sports ceramic clutch, rebuilt by npc rated to 550hp (not even run in)

Head was decked and cleaned when Headgasket was done

All Heater and A/C removed

780cc High-flowed injectors by 6Boost

D1 catch can

Billet radiator overflow and catch can combo

Suspension

G4 fully adjustable coilovers all round

R 180 welded diff

Adjustable castor arms

Adjustable camber arms

Adjustable toe rods

Full 5 stud conversion maintaining drum hand brake

S14 brakes

R32 rack ends

R32 tie rod ends

Power steering rack has had full recondition

Interior

All standard interior and everything works

Pioneer head unit

6” pionner speakers in front doors

Apexi oil temp and water temp gauges(in air vents)

Speco oil pressure gauge (in air vent)

Hydraulic hand-brake, sits in standard position and retains center console

R32 front seats

Monkey floor brace

Laurel floor mats for confusion..

Power Fc computer with hand controller

Deep dish steering wheel

Dilly gearknob

Cusco front and rear strut braces

Outside

Origin Roof wing painted black

33GTR wheels paints custom white (pearl white with silver flakes through it)

Car is painted a GTR grey with metallic flakes through it

215/45/17 Federal 595's Brand new!

Has 1 dint in the left rear quarter, about the size of your palm. Can get fixed for extra but hasnt worried me

New alignment

Fluids

Engine runs Royal Purple 10-40w

Gearbox only uses Redline Shockproof Lightweight gearbox oil

Will get some new pictures this week

164699_191783764166513_5401204_n.jpg

165102_10150127132792279_2084784_n.jpg

32E5ECD7-87FB-4786-A932-0100B8F31598-5234-00000510A51BC8BA-1.jpg

097C987C-C606-4ED3-9507-526B70D7ACEF-3348-000003E5A6BBD7B8.jpg

D415B51E-A345-43E8-B767-571B3B186088-23926-000014694AA73B8C.jpg

Edited by juzz0

Looks great man, do you happen to have any footage of the car from that last pic? Also, where is the car located, and which Matsuri are you referring to?

Car is located in toowoomba, qld( about an hours west of Brisbane). Yeah there is footage. Was referring to QLD matsuri at QLD raceway 2 weekends ago. Car performed brilliantly and had no issue at all. Welcome to all inspections. Car has been my daily for the last few months and Havnt had any un-wanted attention

Edited by juzz0
  • 1 month later...
  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...