Jump to content
SAU Community

Recommended Posts

Timeless, classic wheels. Hard to find these days in these sizes, perfect fit for GTR guards.

18x10 +20 all around.

This set has never been restored, still has the original clear coat on the barrels. Some light guttering on 2 rims which would be easily cleaned up.

Great opportunity to have perfect BBS LM's if you get them restored, or strip the clear and polish them up yourself.

Selling only as the fitment is just too aggressive on my 34 GTT.

jbxmBqXBS43som_xs.jpg jKcVofRHUK3Md_xs.jpg

Pickup only, Ryde.

$3000 ono

O466 495 7O1

Link to comment
https://www.sau.com.au/forums/topic/412634-bbs-lm-18x10-20/
Share on other sites

Timeless, classic wheels. Hard to find these days in these sizes, perfect fit for GTR guards.

18x10 +20 all around.

What tyres are on them and what size are the tyres

This set has never been restored, still has the original clear coat on the barrels. Some light guttering on 2 rims which would be easily cleaned up.

Great opportunity to have perfect BBS LM's if you get them restored, or strip the clear and polish them up yourself.

Selling only as the fitment is just too aggressive on my 34 GTT.

jbxmBqXBS43som_xs.jpg jKcVofRHUK3Md_xs.jpg

Pickup only, Ryde.

$3000 ono

O466 495 7O1

Link to comment
https://www.sau.com.au/forums/topic/412634-bbs-lm-18x10-20/#findComment-6603509
Share on other sites

Took me a while to find your reply there Bill.

At the moment they have 255 and 245 Federal 595's on them. They are pretty rat-shit to be honest, good for skids and that's about it.

Link to comment
https://www.sau.com.au/forums/topic/412634-bbs-lm-18x10-20/#findComment-6603659
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...