Jump to content
SAU Community

1993 (Kouki) Gt-R - Tapping/ticking Noise When Aircon Is On?


Recommended Posts

Hi all,

Pop quiz – what do you think is causing a tapping/ticking noise when my aircon is turned on?

  1. It only occurs when the compressor is engaged, and goes away when the aircon is switched off;
  2. It doesn’t occur when only the climate control fan is on;
  3. It is worse at low revs – particularly at idle
  4. The ‘rate’ of tapping/ticking increases as revs increase but the volume of the noise diminishes as the revs increase (and this is not just because there is more ambient noise);
  5. My aircon works fine, even when the noise is occurring.

The car is a 1993 R32 GT-R. I recently had leaks rectified and the system was regassed with R134a after several years of relative inactivity - i.e. it was sat in a warehouse for a couple of years after being imported and then had occasional use over 3,000km/one year by the previous owner.

Also, all belts, tensioners etc were replaced when I purchased it - this was a precautionary measure as the belts were original (i.e. 19 years old), even though the car had only 66,000km on the clock.

Any ideas would be most appreciated!

Cheers!

Mike

Can you find what area the noise is coming from? It could possibly be a noisey tx valve. I've got a 7 series BMW that hoots honks and ticks occasionally, turns out its a pressure valve that causes weird noises as the gas passes through it, reading up a little I found that the spring that the gas is forcing open gets weak and vibrates.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • 310mm rotors will be avilable from Australia, Japan, and probably a few other places. Nothing for the front can be put on the back.
    • The filter only filters down to a specific size. Add to that, the filter is AFTER the pump. So it means everything starts breaking your pump even if its being filtered out.
    • Just like in being 14mm too small (296mm) makes it not fit, being 14mm too big (324mm) it also won't fit. You want to find the correct rotor.
    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
×
×
  • Create New...