Jump to content
SAU Community

JUN Sump Baffles **NEW**

Merli
 Share

Recommended Posts

Merli Grand Master

Merli

Posted
Posted

Genuine JUN Auto Mechanic Sump Baffles for RB26DETT.

BRAND NEW, Only taken out of box for photos.

http://www.andrewho.com/misc/forsale/junbaffle1.jpg

http://www.andrewho.com/misc/forsale/junbaffle2.jpg

http://www.andrewho.com/misc/forsale/junbaffle3.jpg

http://www.andrewho.com/misc/forsale/junbaffle4.jpg

SOLD.

Link to comment
https://www.sau.com.au/forums/topic/41467-jun-sump-baffles-new/
Share on other sites
mist Community Regular

mist

Posted
Posted

hey andrew, i've asked around b4 but never got a sure reply - are these baffles only suited to the RB26 sump? i'm thinking probably, as they're diff shape aren't they? - 4WD: front driveshafts going through the sump? if they somehow fit RB RWD sump, let me know :)

Merli Grand Master

Merli

Posted
  • Author
Posted

mist: I don't think RB20/RB25's really need it... It's more to do with the flatter and longer design of the RB26 sump that houses the front diff that necessitates the addition of these sump baffles for track work... The RB20/RB25's should be fine...

If you really want to fit these (can't hurt really), give John at Unique Auto Sports a call, he built B-Man's motor and he organise a sump upgrade for it and should be able to tell you whether this will fit into the RB20 sump...

YO880: You can do it either of two ways:

1. Lift the car up on a hoist and support the bottom of the engine with a stand. Remove crossmember and bottom of the sump. Drop in Jun Sump Baffles, and put it all back together. $500-750-ish?

2. Remove engine from car and do it on an engine stand. - $1000-$1500

Most people like doing via Method 2 as it's easier, but if you're paying for labour, I suggest getting them to do it via Method 1 as it will be cheaper.

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • jez NF
      The Evolution Of "night Fury"

      By jez NF · Posted

      Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Predator1
      Tomei gasket

      By Predator1 · Posted

      Didnt realise RB's had more then 1 head.
    • MBS206
      Unpeeling the Orange

      By MBS206 · Posted

      I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • GTSBoy
      Unpeeling the Orange

      By GTSBoy · Posted

      Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • Kinkstaah
      Unpeeling the Orange

      By Kinkstaah · Posted

      The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...