Jump to content
SAU Community

Clutch Release Bearing Questions? S15 6 Speed

jdm32r
 Share

Recommended Posts

jdm32r Enthusiast

jdm32r

Posted
Posted

hey guy just wanted to ask a question about my throw out bearing on my s15,

so it needs to be replaced and it is pretty bad rattle already but still having no trouble with the clutch or drivability, i have it booked in to have it replaced on monday but it is now thursday and drift night dow at archfield raceway, im asking will it survive or should i skip it?

eightsixboy Mentor

eightsixboy

Posted
Posted

If its rattling when the clutch is released its your gearbox not the release bearing. My old 31 box used to rattle at idle, had a buggered imput shaft bearing.

A release bearing will make a noise when pressing in the clutch only.

jdm32r Enthusiast

jdm32r

Posted
  • Author
Posted

If its rattling when the clutch is released its your gearbox not the release bearing. My old 31 box used to rattle at idle, had a buggered imput shaft bearing.

A release bearing will make a noise when pressing in the clutch only.

yeah it only rattles when i push in the clutch

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      R34 25GT Engine Light 21

      By GTSBoy · Posted

      If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • The Bogan
      SAU NSW - R U OK? Southern Highlands Cruise

      By The Bogan · Posted

      Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Duncan
      SAU NSW - R U OK? Southern Highlands Cruise

      By Duncan · Posted

      Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Duncan
      Duncan's V37.......race car?

      By Duncan · Posted

      Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...