Jump to content
SAU Community

Recommended Posts

Hey guys, so my gfs r34 is now playing up. I ran a diagnostic check and it comes up with fault code 43, which is a tps mal fuction. Now i tried to re calibeate the tps but nothing happens.

Issues im having include fluctuating idle and slipping trans while in drive as in the drive will engage then disengage constantly. When the car comes to a stop sometimes the revs will drop to as low as 300-400 rpm. It will stay like that constantly but when you blip the throttle it will return to around 700-900 but quickly drop back down to 300.

Ive tried jiggling the clips and they seem to make the revs climb and drop sometime to stall point. Ive tried adjusting the tps but this does not fix it.

Wondering if anyone has had this problem. Im guessing the tps is munted or the wiring is causing the issue. Has anyone had this problem?

Link to comment
https://www.sau.com.au/forums/topic/420280-rb25deneo-tps-malfunction/
Share on other sites

The car is still playing up, however its only doing it during the day when its hot? Drove the car for 20 mins at night but was fine. This leads me to think its an over heating issue with the electrics tripping out?

No one has had this problem?

Today the intermittent gearbox slipping reared its ugly head to the point the whole drive train seemed to short out or cut out, the 'D' light flickered off as the car lost all power and drive, i shifted it into manual mode and the lights intermittently flickered between '3' and 'D' while A/T was flashing, lost all power still and car coughed and spluttered. pulled up at lights and turned car off, turned it back on and a/t was flashing and still ahd no go and no normal gearbox operation. still getting a tps code. im at the point where im just going to buy a new tps sensor.

I dont think anyone can help on here by the looks of it.

Thanks mate, i did an hours worth of look last night found it on here somewhere someone has had a similar problem, they change gbox solenoids, veh. Speed sensor, tps and the problem still exists.... So wanna start on the ruling out part of the job.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • About $4k brand new, available from vendors in Oz, or via an importer from Japan. Although that is for an R34 box, so you also need to buy the push clutch front plate (brand new from Nissan) and swap that over, and drill the bellhousing for a push clutch slave cylinder.
    • Absolutely could be. I collected data logs from when the O2 sensor was still out and also after I had replaced it so will try to compare them. Pretty confident that the affect is lowered with the new sensor, will check logs at the same RPMs/conditions. 
    • Hey guys Long time lurker, I daily a nm35 stagea 250t rs four and I've had it for almost 2 years (very reliable 👌). Issues or just looking for information ill always find myself here having a read, so thought id join.  3inch stainless intake, pod filter, AM performance turbo dump pipe, 3inch hotdog, 3 and half inch stainless to 3 and half inch AM performance blast pipes. Bc racing coilovers. 18inch rims Hdi intercooler and trans cooler soon.  Here's my car
    • thanks for the advice on the box... i was thinking the 6 speed was better for cruising on the highway but on closer inspection and comparison the Rb 5 speed box was not too different...  So the choice is going to be the RB25 box... if I can save up and find one at the right price  
    • Thanks Matt, yes that's what i am aiming for. Just going to apply the right voltage and grounds to the dash connector. Hence my search for these pins... any chance you know if these pins are in the same spot as the ones on the S15 Dash connector? as mentioned above on page 8?
×
×
  • Create New...