Jump to content
SAU Community

Battery Warning Light Always On When Car Runs Fine. What's Wrong?

Spunky Munky

By Spunky Munky,
in General Maintenance

 Share

Recommended Posts

Spunky Munky Grand Master

Spunky Munky

Posted
Posted

Hi guys, recently my R33 GTR's battery warning light started flashing and now remains permanently on when the car runs fine and shows no signs of stalling or drained of power. What's going on and how to fix?

Firstly, I had the car at a motor mechanic for a couple of months where it was hardly driven each day so is the battery dead? This battery was brand new and only replaced 5 months ago. Ever since taking the car home, it's been on a trickle charger and only driven monthly but the charger does indicate that the battery has been fully charged so not sure why this is happening.

Recently, my amp/sub combos earth wire going from the "control" went loose so I had to fix and it sparked a few little sparks which is normal so not sure if this had anything to do with it. I assume not ?

Any help would be much appreciated.

DVS JEZ Grand Master

DVS JEZ

Posted
Posted

alternators have 2 circuits. one for charging and one for the warning light. sounds like the warning light circuit may be faulty. get a multimeter and check the charging voltage on the battery terminals to be sure the alternator is charging correctly

kitto Mentor

kitto

Posted
Posted

The warning light is a part of the excitation circuit through the regulator.

The regulator is most likely on the way out.

When that circuit fails the alternator stops producing charge as there is no excitation current to produce an electro-magnetic field inside the armature.

Spunky Munky Grand Master

Spunky Munky

Posted
  • Author
Posted

Update: so the problem got worst. Slowly the battery just won't hold charge anymore and eventually I found myself stuck in the middle of the road with no power so it's at a friends house now.

You guys think the alternator is home or more the battery dead?

I'm leaning more toward the battery.

kitto Mentor

kitto

Posted
Posted

Alternator for sure.

The tell tail signs are there.

The battery warning lamp was coming on notifying you that the alternator was starting to fail. Eventually it did completely fail and the entire car from that point on ran off the battery which then lead to a complete flat battery and your car stuck in the middle of a road.

Replace the alternator, stick the battery on charge for 24 hours and you should be good to go.

Spunky Munky Grand Master

Spunky Munky

Posted
  • Author
Posted

Thanks guys. Really appreciate it. I will get it looked at by a mechanic this weekend. Hopefully this will serve as a lesson for others.

Cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • GTSBoy
      Nissan fuga 450gt android screen

      By GTSBoy · Posted

      So, now all you need to do is connect the 2 or 3x 12v feeds into the unit to permanent 12v, ACC 12V and IGN 12V that you can find in the spot behind the stereo, and the earth, and then it will switch on with the car.
    • The king 2.0
      Nissan fuga 450gt android screen

      By The king 2.0 · Posted

      Yes then it will turn on but I want the car features to work  
    • GTSBoy
      NC MX5

      By GTSBoy · Posted

      My thought is if you were just moving it forward and the upstream geometry remained the same, then no difference at all. But because the current one has the filter direct into the AFM inlet, you effectively have the best chance of a completely symmetric air flow profile upstream, and in, the AFM, whilst the aftermarket inlet thingo has a (small, to be sure) bend between the filter and the AFM. That would bias the flow to the outside of the bend (downstream of the bend) which might well reduce the size of the signal seen by the AFM, for the same total flow rate. Having said that: If you're proposing to make your inlet look like a hybrid of your existing one and the aftermarket one, such that there is no bend where the filter is clamped on... then I say it will be just fine. If there is going to be such a bend, then, if you can align the insertion of the AFM blade such that it is at right angles to the plane of the bend, then there is a better than even chance that the centreline velocity where the blade is will remain more or less the same, and the velocity will just be a little faster to the outside of that, and just a little slower to the inside. **This is not professional investment advice and you should consult a suitably qualified ouija board, tea leaves or the intestines of a goat for more accurate prognostication.
    • pacman_1219
      Blue/grey smoke after idle

      By pacman_1219 · Posted

      Hi Tao, Thanks for your reply.  It's been a while and I managed to get the valve stem seals replaced with the head on the car.  Unfortunately this didn't solve my issue, the car still smokes a lot after idling (to be honest during idle you can see a bit of blue smoke from the exhaust), same after deceleration. I will try disconnecting the valve cover breathers, do I leave the PCV valve in? By engine oil drain pipe, do you mean the turbo oil drain?
    • GTSBoy
      Nissan fuga 450gt android screen

      By GTSBoy · Posted

      What about if you just give it direct 12v and earth?
×
×
  • Create New...