Jump to content
SAU Community

Recommended Posts

Can anybody help me before I go male beserk and lose the will to live? I just got a mitsubishi rvr hypersport from Japan......blinding car but the feckin audio system didnt have an instruction booklet. I tried Pioneer but apparently they were dead at the time when this audio was made by their company!

I'm just a thick pom who needs to play my favorite englbert humperdink remixes whilst checkin out the talent, so does anybody know where I can get an instruction book, or does anyone know how the poxy thing works!!!

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/42753-carrozerria-deh-p-990/
Share on other sites

It is, and I can get the required noises, but some of the finer points are a pain, i.e how to fade between front/rear, using preprogrammed equalizer mode and general operation. Pity cos I think it could be a good system if I knew how to properly use the feckin thing!

i had this head unit my r33. its a good head unit. made by carrozerria which is pioneer japanese domestic,. you wont get a manul for it. if you have the remote you can use the function or audio button on it. or on the head unit you can use the function button, hold it down.

mine didnt come with a remote and the function button was broken so i couldnt do much with it. if it doubt get a new head unit with the correct audio frequencies as it will only go from 76 to 89

if u push and hold the audio button or function button it should give the eq settings for each band....this can be changed so u can adjust all the seperate frequencies from 80hz to 3.3khz i think.....if u play with this then u will be able to adjust the sound.....also if u turn the unit OFF while the car is ON then press and hold the FUNCTION button it will bring up a seperate menu where u can adjust the clock and brightness settings etc

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • As MBS suggested if this is happening when the engine is cold you're going to want to remove the intake air regulator and verify resistance + that the shutter is physically opening and closing. At -20C should be fully open, 20C half open, over 60C fully closed. At 20C should be 70-80 ohms. For AAC valve testing using a Consult cable see if you can raise and lower the idle by commanding more or less AAC duty cycle. Hopefully it's pretty linear as well, shouldn't be like 30% AAC valve is barely idling and 40% is 1500 rpm.
    • Bloody apprentices! 🙄
    • Not sure yet.  Was considering speedtek because it was rated to 800hp, but when I did some research about him I don't think I will go for that🤣 So maybe giken gear set, but I'm afraid it won't be strong enough🙄
    • Keeping in mind that for most people this is a week to month long job!
    • Its also worth mentioning that 30 years after it left the factory and god knows how many missed oil changes since, there is every possibility that one or more lifters are ticking because they are sticky/gummed up. To resolve that you need to pull the cams then pull each lifter, disassemble, clean, reassemble, soak in oil and re-install, and they should come up good as new.
×
×
  • Create New...