Jump to content
SAU Community

Recommended Posts

Hi iv got a r32 skyline running a rb25det, I'm getting what I'm thinking is turbo surge in 3rd gear, starts making a woowoowoo type sound, lol, and feels like I'm hitting a big flat spot ,

This is my setup

Rb25det

Garrett gt3082 ar70 front housing with a 64 rear housing , 20 psi boost

900cc injectors

Walbro 255lph in tank

Fuel pressure regulator

Aftermarket coil packs

External wastegate

Apexi boost controller

Haltech platnuim pro ecu

Making 395 horse atw,

Any info would be great please so I can figure this out

Link to comment
https://www.sau.com.au/forums/topic/429659-rb25det-garrett-gt30-turbo-surge/
Share on other sites

I know that noise. My op6 did it when I wound the boost up. I also found that the boost was spiking when it made that noise. I just wound the boost down to stop it. Have you been running 20psi for a while and it's just started now? Or have you just wound up the boost recently? It's usually caused from the turbo flowing more air than it can handle.

It seemed fine on my dyno pull when it was tuned to 20psi . But I noticed it at my first drift event with the new setup, maybe I need a 82 rear housing? Cauld my 64 be to small ?

Ok so I took it for a drive yesterday, I noticed it back firing alot,and almost felt surge in 2nd gear now, also my battery keeps going flat, so further investigation and iv found that my alternator has had it, broken. So I'm hoping maybe this caused all my issues and may be fixed once replaced

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...