Jump to content
SAU Community

Recommended Posts

Hi Everyone,

Its that time again and I need to clear out all the parts that I don't require anymore. The reason for the sale is that I have upgraded to full adjustable suspension and the left over motor bits are not required with the RB26/30 setup. All parts were all still functioning when the motors were removed and have all been stored in the garage and now I need the room. Parts are all used and still in great condition. Im located in Adelaide, SA and can ship goods to buyer at his/her expense. All parts are out of a series 1 GTR and GTSt R33!

- oil cooler $30

- air regulator $30

- GTST diff centre $150 (no ring gear)

- generic 12' thermo fan $60

- HICAS steering unit with tie rods $100

- upper camber arms from GTST $20 each

- GTST disc brakes and calipers $ 250 (front and rear)

- gtst intake pipe $10 both turbo intake pipes

- GTR O2 sensors (3) $10 the lot

- vacuum/ water lines $10 (2 sets)GTR

- vac ballast tube $20 GTR

- Blitz blow off valve $70

- trust pod filter $40

- green label air flow meter $40

- rear main crank seal $10

- GTR crank scraper (both) $10

- GTR water pump (no cavitation) $20

- gtst washer bottle $20

- gtst rear camber arms $10 each

- gtst rear traction rods $10 each

- gtst clutch fan $20

- gtst castor rods $20 each

- gtst front LCA'S $30 each

- gtst rear LCA'S $30 EACH

- GTR turbo oil and water line $10

- Gtst full exhaust (mild steel) $100

- gtst A/c lines and condenser $50

- gtst s1 centre grille $80

- bosch 464 fuel pump $10

- gtr thermostats 76.5 deg $5 each (2)

- s1 gtst manual gear set (minus centre plate) $400

- gtst fuel tank $50

- gtst fuel pump assembly $60

buyer to pay for postage of goods!

PICS UP SOON :)

Cheers HULI

FOR ALL THOSE PEOPLE ASKING THE BRAKES ARE IN EXCELLENT CONDITION AND WERE ONLY REPLACED WITH NEW 8 POT AND 6 POT CALLIPERS AND ROTORS.

THE STOCK CALLIPERS AND ROTORS COME WITH THE BRAKE PADS THAT WERE ON THERE AND THE ROTOR THICKNESSES FOR THE FRONT ARE 29.5MM AND THE REARS ARE 19MM.

HOPEFULLY CLEARS UP ANY QUESTIONS

MIGHT EVEN SEPARATE THE SET IF NEEDED!

FRONT LCA'S ****SOLD PENDING PAYMENT****

VACUUM/WATER LINES (1 SET) ****SOLD PENDING PAYMENT****

CLUTCH FAN ****SOLD PENDING PAYMENT****

GTR TURBO OIL AND WATER LINE ****SOLD PENDING PAYMENT****

LOTS OF OTHER EXCELLENT PARTS STILL UP FOR GRABS!

All reasonable offers will be considered on any of the parts above.

LOW BALLERS WILL GET NO RESPONSE AT ALL!

LOTS OF GREAT STUFF STILL AVAILABLE!!!!

PM ON HERE OR MSG/CALL 0400262578

FORGOT TO MENTION THAT I HAVE SET OF GTR DUMP PIPES(WITH HEAT SHIELDS) AND ONE SPARE (WITHOUT) $15 EACH. PUT THE PIC UP BUT NO PRICE OR DESCRIPTION :(

LOTS OF PEOPLE MSGING BUT NO TAKERS. ALL QUALITY USED PARTS!!!

REASONABLE OFFERS ARE WELCOME. AT THESE PRICES THEIR PRETTY MUCH A STEL ANYWAY.

P&H IS BUYERS EXPENSE.

CHEERS HULI

offers are welcome people. all suspension arms $10 each

callipers and rotors $150

need the space, so want all this stuff gone and soon!

CHEERS HULI

help clear out these quality parts. None of the parts has ever been involved in any accident or mistreated. It was all functioning perfectly when removed and replaced by new parts. Need the room in the shed to finish off the car.

CHEAPEST PRICES I HAVE SEEN THESE PARTS ON THIS FORUM..

OFFER ARE WELCOME. SHOOT ME A PM ON HERE OR CALL/MSG ME ON 0400262578

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah well per the video it took 15s for the stock unit to start up....even if I give it a few seconds discount for starting that is at least 12 sec before you get a reverse camera if you are trying to leave a park.  The android unit is way faster, but 2016 for the stock unit is a long time ago in consumer electronics
    • Yea that’s why I said ima test them with multimeter and see the reads.
    • Only at idle. Isn’t a problem when rev it seems.
    • @Haggerty This seems silly to ask, but are you confident in your ability to tune the Haltech?  
    • Next on the to-do list was an oil and filter change. Nothing exciting to add here except the oil filter is in a really stupid place (facing the engine mount/subframe/steering rack). GReddy do a relocation kit which puts it towards the gearbox, I would have preferred towards the front but there's obviously a lot more stuff there. Something I'll have to look at for the next service perhaps. First time using Valvoline oil, although I can't see it being any different to most other brands Nice... The oil filter location... At least the subframe wont rust any time soon I picked up a genuine fuel filter, this is part of the fuel pump assembly inside the fuel tank. Access can be found underneath the rear seat, you'll see this triangular cover Remove the 3x plastic 10mm nuts and lift the cover up, pushing the rubber grommet through The yellow fuel line clips push out in opposite directions, remove these completely. The two moulded fuel lines can now pull upwards to disconnect, along with the wire electrical plug. There's 8x 8mm bolts that secure the black retaining ring. The fuel pump assembly is now ready to lift out. Be mindful of the fuel hose on the side, the hose clamp on mine was catching the hose preventing it from lifting up The fuel pump/filter has an upper and lower section held on by 4 pressure clips. These did take a little bit of force, it sounded like the plastic tabs were going to break but they didn't (don't worry!) The lower section helps mount the fuel pump, there's a circular rubber gasket/grommet/seal thing on the bottom where the sock is. Undo the hose clip on the short fuel hose on the side to disconnect it from the 3 way distribution pipe to be able to lift the upper half away. Don't forget to unplug the fuel pump too! There's a few rubber O rings that will need transferring to the new filter housing, I show these in the video at the bottom of this write up. Reassembly is the reverse Here's a photo of the new filter installed, you'll be able to see where the tabs are more clearing against the yellow OEM plastic Once the assembly is re-installed, I turned the engine over a few times to help build up fuel pressure. I did panic when the car stopped turning over but I could hear the fuel pump making a noise. It eventually started and has been fine since. Found my 'lucky' coin underneath the rear seat too The Youtube video can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44&t=6s
×
×
  • Create New...