Jump to content
SAU Community

Recommended Posts

Hi Everyone,

Its that time again and I need to clear out all the parts that I don't require anymore. The reason for the sale is that I have upgraded to full adjustable suspension and the left over motor bits are not required with the RB26/30 setup. All parts were all still functioning when the motors were removed and have all been stored in the garage and now I need the room. Parts are all used and still in great condition. Im located in Adelaide, SA and can ship goods to buyer at his/her expense. All parts are out of a series 1 GTR and GTSt R33!

- oil cooler $30

- air regulator $30

- GTST diff centre $150 (no ring gear)

- generic 12' thermo fan $60

- HICAS steering unit with tie rods $100

- upper camber arms from GTST $20 each

- GTST disc brakes and calipers $ 250 (front and rear)

- gtst intake pipe $10 both turbo intake pipes

- GTR O2 sensors (3) $10 the lot

- vacuum/ water lines $10 (2 sets)GTR

- vac ballast tube $20 GTR

- Blitz blow off valve $70

- trust pod filter $40

- green label air flow meter $40

- rear main crank seal $10

- GTR crank scraper (both) $10

- GTR water pump (no cavitation) $20

- gtst washer bottle $20

- gtst rear camber arms $10 each

- gtst rear traction rods $10 each

- gtst clutch fan $20

- gtst castor rods $20 each

- gtst front LCA'S $30 each

- gtst rear LCA'S $30 EACH

- GTR turbo oil and water line $10

- Gtst full exhaust (mild steel) $100

- gtst A/c lines and condenser $50

- gtst s1 centre grille $80

- bosch 464 fuel pump $10

- gtr thermostats 76.5 deg $5 each (2)

- s1 gtst manual gear set (minus centre plate) $400

- gtst fuel tank $50

- gtst fuel pump assembly $60

buyer to pay for postage of goods!

PICS UP SOON :)

Cheers HULI

FOR ALL THOSE PEOPLE ASKING THE BRAKES ARE IN EXCELLENT CONDITION AND WERE ONLY REPLACED WITH NEW 8 POT AND 6 POT CALLIPERS AND ROTORS.

THE STOCK CALLIPERS AND ROTORS COME WITH THE BRAKE PADS THAT WERE ON THERE AND THE ROTOR THICKNESSES FOR THE FRONT ARE 29.5MM AND THE REARS ARE 19MM.

HOPEFULLY CLEARS UP ANY QUESTIONS

MIGHT EVEN SEPARATE THE SET IF NEEDED!

FRONT LCA'S ****SOLD PENDING PAYMENT****

VACUUM/WATER LINES (1 SET) ****SOLD PENDING PAYMENT****

CLUTCH FAN ****SOLD PENDING PAYMENT****

GTR TURBO OIL AND WATER LINE ****SOLD PENDING PAYMENT****

LOTS OF OTHER EXCELLENT PARTS STILL UP FOR GRABS!

All reasonable offers will be considered on any of the parts above.

LOW BALLERS WILL GET NO RESPONSE AT ALL!

LOTS OF GREAT STUFF STILL AVAILABLE!!!!

PM ON HERE OR MSG/CALL 0400262578

FORGOT TO MENTION THAT I HAVE SET OF GTR DUMP PIPES(WITH HEAT SHIELDS) AND ONE SPARE (WITHOUT) $15 EACH. PUT THE PIC UP BUT NO PRICE OR DESCRIPTION :(

LOTS OF PEOPLE MSGING BUT NO TAKERS. ALL QUALITY USED PARTS!!!

REASONABLE OFFERS ARE WELCOME. AT THESE PRICES THEIR PRETTY MUCH A STEL ANYWAY.

P&H IS BUYERS EXPENSE.

CHEERS HULI

offers are welcome people. all suspension arms $10 each

callipers and rotors $150

need the space, so want all this stuff gone and soon!

CHEERS HULI

help clear out these quality parts. None of the parts has ever been involved in any accident or mistreated. It was all functioning perfectly when removed and replaced by new parts. Need the room in the shed to finish off the car.

CHEAPEST PRICES I HAVE SEEN THESE PARTS ON THIS FORUM..

OFFER ARE WELCOME. SHOOT ME A PM ON HERE OR CALL/MSG ME ON 0400262578

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
    • Thanks for the replies everyone. Definitely a coolant push. Oil catch can is empty and always has been. As the engine is out now I'll be having a good look over things. I do have some detonation on the piston tops from a trigger issue back about 5 years ago. I felt it and shut off then bought a new ecu and changed the trigger. Never been an issue since. It never hurt the power, its made almost 80hp more since that incident but I will pull the bearing caps to take a look. If the bearings are damaged I will do a bottom end refresh. Head is being re conditioned at the moment and the block will be cleaned and checked to ensure it's flat. I'll go with a kameari gasket and see how it ends up. The other thing I'm not super keen on is the cylinder colours. I suspect this is from the inlet manifold. The plan will be to put it back together, retune and then stick a plazmaman billet inlet on it and retune. I'm happy with the power, if it makes a little more, then great, but I would rather just make everything more efficient at this stage.
    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
    • Does it also misfire equally when revving?   Josh is very correct in what you should do. The coilpack harness wiring loom itself is a known problem due to its age and the number of heat cycles it has gone through. Throwing parts at a vehicle to diagnose the issue isn't a smart or good way to do it. Secondly, you may have a bad coil pack, you pop replacements in, they fix that issue, but messing with the harness breaks it, so the issue persists. So now you think "well it wasn't the coil packs" and have to continue chasing your tail, potentially swapping back in your shit coil packs and returning the good ones (yes, I've seen people do this because 'it wasn't the problem' and they want to save money). And suddenly, you've got two issues with the same symptoms...   Diagnose, don't use the spare parts shotgun.
×
×
  • Create New...