Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

I just want some cheap 4/5 stud wheels to throw some track tires on, so that I can run them on either car

Now, probably wasting my time, but I have these lying around (tyres not included, unless you want to pay a lot extra)

Do you like roller blades? (narrow is good for skidz..., ask anyone who spent too much on an underpowered 86) :D

Have some 17x7" 45mm offset wheels with 4/5 stud pattern

Enkei 'Orsh Varents'

post-78416-0-66140700-1401792128_thumb.jpg

post-78416-0-17934800-1401792170_thumb.jpg

(the worst one, some nicks on the others though)

post-78416-0-10006300-1401792193_thumb.jpg

Recently repaired and refurbished by Depulu Wheels (courtesy of a suspension shop who doesn't know how to put wheel nuts on the right way around),

Then re-rashed by a clumsy Legnum driver (who never once rashed them himself until after they were refurbed :'( )

And incase you think they are just for 'fagnums', here is one of the only pics of the same wheels on the internet

post-78416-0-76477300-1401792726_thumb.jpg

(no idea if offset is the same though)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
×
×
  • Create New...