Jump to content
SAU Community

Recommended Posts

First checkout the link below for proof I'm an ebay POWER SELLER and can be trusted to post items:

http://feedback.ebay.com.au/ws/eBayISAPI.dll?ViewFeedback2&userid=iphone.addiction&ftab=FeedbackAsSeller

As seen in the link below the RRP was $1075 USD = over $1200 AUD + Postage from the USA:

http://www.blitzpowerusa.com/products/sbcicolor/sbcicolor.html

Was fitted to my 2nd car which I rarely drove, I can guarantee this boost controller had done less than 2000km's!

Everything you need for the install is included & the Installation Manual is attached!

$550

Pick up from Wyndham Vale VIC (sometimes Dover Heights NSW)

Or

Postage with Tracking $20 or with Signature $23

Contact Brett at [email protected]

post-60944-0-66555100-1382999266_thumb.jpg

post-60944-0-40703700-1382999560_thumb.jpg

post-60944-0-18114100-1382999581_thumb.jpg

post-60944-0-29445100-1382999590_thumb.jpg

SBC i-Color Eng.pdf

Edited by Sydneyactionman

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Have you flushed the initial fluid yet? It should look like a rainbow unicorn shat glitter into it. 2nd or 3rd fluid change is when you party.
    • all brand new unit from Tomei, fluid, bearings, etc. Tomei said they call it a 1.5 lsd because its 100 percent lock up under acceleration and 50 percent under deacceleration.  as I mentioned I used their fluid, install and their break-in procedure, (alot of figure 8's) but even when driving straight, or even slowly backing out of garage for first time, (at 2 mph) then driving to and from figure 8 parking lot, each tire in the rear would sporadically grab, skip, bounce, shutter and skip, shutter back a force I could feel causing clutch to slip then grab, at any speed. shaking entire car. I removed unit, since I put stock back in and all is fine, via process of elimination, its something with the lsd unit itself. I wasn't going to beat up the entire car more or change anything else for no reason as I had a feeling something in the lsd itself was wrong as everything was fine before this alone was installed and I rechecked over everything else after first time backing out I suspected an issue. I'll probably sadly already need new tires now just from trying to drive it 5 miles and performing the figure 8 break in. but if someone has any ideas I'm all ears 
    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
×
×
  • Create New...