Jump to content
SAU Community

Recommended Posts

2 x Brand new HKS Pod Filter Elements - $50

Blitz Dual SBR Boost Controller - New - $400

http://www.nengun.com/blitz/sbc-spec-r-dual-solenoid- For reference

Nismo Group A streering wheel in box - Brand New with genuine horn button - $400

QLD Personalised plates "27GTR" Yellow on Black colour Scheme - $500

Pivot Shift Light - Good condition - $50

GFB Boost Tee - Good condition - $20

All prices negotiable, pictures available on request.

Drop me a line if interested.

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/440060-parts-cleanout-rb26/
Share on other sites

My apologies to those who have recently texted me.

My phone blew up and I have a loan phone from Telstra and therefore, no numbers.

Anyone interested please text me again on the same number.

Also for sale.

ARC Radiator air guide, like new condition - $100

HKS Filter cages and Elbows (with hks nuts) - $100

Blitz Dual SBC dual solenoid Boost controller - $300

Full set of RDA Slotted brakes for R32 GT-R (Brand new) - $250

All Prices negotiable.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...