Jump to content
SAU Community

The inevitable has happened..

SLY33

By SLY33,
in South Australia

 Share

Recommended Posts

predator Grand Master

predator

Posted
Posted
Currently there is also a national agreement where if your car is defected in QLD, and it is registered in another state, you can have the defect cleared in the state it was defected or the state of registration.

But when you go to register a car in another state. A cop isn't able to look interstate details up "on the spot" on their system (as far as I know).. so how can an NSW cop even tell your car is unregistered on SA plates if they saw your car driving along?

When you go to get the defect cleared you need to get a RWC, safety certificate or whatever anyhow. Funnily enough, pretty much all states require you to get RWC in that state when changing the car between states. E.g. to register a car from another state rego'ed in QLD i have to get a safety certificate issued in QLD. If its "defected" and unregistered it doesn't really matter does it? I still have to present a safety certificate to get it registered in the other state.

it was only recently that points were transferred.. and then not always that is done properly

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      S1 rb25/s14 starting problem

      By MBS206 · Posted

      I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Duncan
      S1 rb25/s14 starting problem

      By Duncan · Posted

      Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Waders360
      M35 Brake caliper replacement

      By Waders360 · Posted

      Sorry. Front brake calipers
    • MBS206
      S1 rb25/s14 starting problem

      By MBS206 · Posted

      Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...