Jump to content
SAU Community

Wanted:gt-R35 To Take My Partner For A Spin. Only 1 Hour Of Your Time! Partners Dream Come True! Please Read Before Judging!

ViintageBarbiie

By ViintageBarbiie,
in R35 GTR

 Share

Recommended Posts

ViintageBarbiie Rookie

ViintageBarbiie

Posted
Posted

I am Looking for someone who has a R35 In the Brisbane area but I can travel but not something stupid like 4 hours.

My partners 21st is in a couple of months and his DREAM car is the R35. Im wanting someone who can take 1 hour of there time to take him for a drive ( You Drive ) and I am willing to pay for your time and fuel.

It would mean the absolute world to my partner and he is a car enthusiast and he see's R35's at Queensland raceway and he just wishes he could have one lap.. But I've been to scared to ask so someone please help and make my partners Dream come true!!

Im willing to travel to Goldcoast areas, Toowoomba, right through to nambour and sunny coast!

SOMEONE PLEASE HELP! :(

post-135442-0-49813200-1404635189_thumb.jpeg

  • Like 1

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Latest Posts

    • PranK
      2001 R34DE

      By PranK · Posted

      R34DE as in R34 with an RB25DE? So did you get this? Or you planning to?  I'm not really sure what you're saying. 
    • Dose Pipe Sutututu
      What should I do next to hold the head on

      By Dose Pipe Sutututu · Posted

      Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • GTSBoy
      boost source Size Garrett gt28 gen2

      By GTSBoy · Posted

      Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Dose Pipe Sutututu
      boost source Size Garrett gt28 gen2

      By Dose Pipe Sutututu · Posted

      Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • timmy94
      boost source Size Garrett gt28 gen2

      By timmy94 · Posted

      1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
×
×
  • Create New...