Jump to content
SAU Community

Recommended Posts

17 INCH CE28 Genesis Limited Edition

For sale are a rare set of 17 inch CE28 genesis limited edition.

Size is 17x9.5 +28 offset. Will suit a variety of cars such as Evo 6, S13 S14 S15 Silvia, Skylines etc.

Tyres are in good condition, Ku36 in 235/45/17.

Wheels are also in good condition, virtually no gutter rash.

There were only 500 sets of these wheels made in this specifications, these are extremely rare wheels they even come with a carbon fibre sticker attached to them!

Price is $2500 firm. sms offers and lowballers will be ignored.

im not in a hurry to sell these wheels. i believe these wheels are worth the asking price. this is more of a eoi.

No trades please as i do not have enough room for more wheels.

Please PM or contact 0433 832 973 if you are interested.

Pickup from vermont south, i can ship interstate but buyer must organise shipping.

post-50952-0-41944100-1421495758_thumb.jpg

post-50952-0-40731600-1421495776_thumb.jpg

post-50952-0-82101000-1421495785_thumb.jpg

post-50952-0-10149800-1421495795_thumb.jpg

post-50952-0-56233500-1421495804_thumb.jpg

  • 2 weeks later...
  • 4 weeks later...
  • 2 weeks later...
  • 1 month later...
  • 2 weeks later...
  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...