Jump to content
SAU Community

Recommended Posts

Gday guys

I was wonderig if anyone out there had]s experienced the problems i am having with my misfiring engine. Currently the engine accelerates up to 3000-3500 ok. The problems then start. If I try to accelerate using full throttle the engie misfires and pops out the exhaust. It feels really flat and hesitant. Once the engine finally reaches approx 5500-5800 it takes off like a rocket all the way to the limiter. I am having thoughts on the coils and perhaps exhaust cam timing.

Mods are:

Hi flow turbo, 3" inch mandrel turbo back, plug gap 0.7, boost set at minimal 12psi,

checked A/F ratios , are fine,

If anyone has any thoughts could you please assist before i need to start spending big bucks, Knowledge in Tassie is minimal as the low volume of these vehicles.

Cheers

Nick

Link to comment
https://www.sau.com.au/forums/topic/46767-misfiring-rb25det/
Share on other sites

Hi Nick,

Am interested to know what kind of boost you are running. Is the amount of boost dropping off at high rpm? I ask this because it is harder for a spark to jump the same gap in a higher density atmosphere. Reducing the gap or cutting back boost may prevent the car misfiring, but will put a dent in your performance as well.

I'd be inclined to try out a set of Bosch Super 4 spark plugs if you can get a set to suit, as they do provide superior ignition. Otherwise you may need to get a set of coils or an ignition module with a stronger output depending on which is holding it back.

Link to comment
https://www.sau.com.au/forums/topic/46767-misfiring-rb25det/#findComment-950796
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hey guys Long time lurker, I daily a nm35 stagea 250t rs four and I've had it for almost 2 years (very reliable 👌). Issues or just looking for information ill always find myself here having a read, so thought id join.  3inch stainless intake, pod filter, AM performance turbo dump pipe, 3inch hotdog, 3 and half inch stainless to 3 and half inch AM performance blast pipes. Bc racing coilovers. 18inch rims Hdi intercooler and trans cooler soon.  Here's my car
    • thanks for the advice on the box... i was thinking the 6 speed was better for cruising on the highway but on closer inspection and comparison the Rb 5 speed box was not too different...  So the choice is going to be the RB25 box... if I can save up and find one at the right price  
    • Thanks Matt, yes that's what i am aiming for. Just going to apply the right voltage and grounds to the dash connector. Hence my search for these pins... any chance you know if these pins are in the same spot as the ones on the S15 Dash connector? as mentioned above on page 8?
    • Yes, unfortunately that's the one. Signal was noisy to begin with; after driving once and looking back at the logs I saw pressure constantly swinging between 0-200psi, or staying at 0 randomly for a few seconds. There's a lot of good sensors that share the same look and feel, so don't presume they're all bad. I bought mine for 20$ off Amazon and I should have read the reviews prior, as it's clear they're junk.  I purchased a lowdollerr motorsports sensor. 
    • wedding eh.....I seem to get to more funerals than weddings or christenings these days....
×
×
  • Create New...