Jump to content
SAU Community

Recommended Posts

Remote Starter Engsta Z

Hi Everyone and just thank you in advance for any help you can provide..

I just got my Elgrand 2004 e51, Sydney  it came with one of these silver engsta remote  starter and have not been able to get it to work.

so I downloaded the Japanese manual , used google translator to translate the whole document and did  the car  registration  bit and seemed to have accepted it.

Batteries are fine on the remote, when I press start on the remote ( hold down ) it beeps twice  and then a 2 seconds later its followed by another 2 beeps ( different pitch ) with an orange light.

I tried it with the main unit switched on and and switched off...

When I turn the main unit on, it beeps 3 times.

I have read about immobilisers, mine is just whatever is standard on the car, not even sure if it is an immobilizer.. ( red key light flashes on the dash )

I've attached the manual ( japanese ) if someone could help me would be much appreciated.

Or.. if I have to take it to somewhere , suggestions?

 

Cheers

 

 

 

 

Engsta-Z-installation-insturuction-manual.pdf

Edited by wchau
missing information
Link to comment
https://www.sau.com.au/forums/topic/472023-remote-starter-engsta-z/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
×
×
  • Create New...