Jump to content
SAU Community

Recommended Posts

its harder to sell any car when its close to 100thou

its because of the timing belt and major service

if the car has been done then good but if it hasnt then you will have to get a service done that will probably cost you ~$1k because of the labour involved in changing the timing belt....also it can be higher and lower than that depending what other stuff may need changing, brake disks, pads, stuff like that...

Link to comment
https://www.sau.com.au/forums/topic/55685-urgent/#findComment-1084641
Share on other sites

to me, the 100k mileage means fark all if the car has been well kept and maintained..

as long as all servicing has been carried out as required.. and compression is good... and car is in good condition for its age.. then mileage shouldnt matter so much esp if its 120k..

not like its 400k taxi mileage :)

Link to comment
https://www.sau.com.au/forums/topic/55685-urgent/#findComment-1084780
Share on other sites

100k is the old fabled stupid "dont touch this car" attitude. over 100k is fine as bam said, if it's been properly maintaned.

The nissan engines can last a lifetime, regardless of it's redline life.

I service my car religiously every 4000k's and its never missed a beat :D

Link to comment
https://www.sau.com.au/forums/topic/55685-urgent/#findComment-1085079
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
    • I just stack 2 pieces of 200x50 timber on top of each other. Total length about 900mm, with the top one being a little shorter and both having a 45° angle cut on them to make the front edge a bit of a ramp. Put these in front of each front wheel, drive up on them, throw the trolley jack under. Takes 1 minute. Scissor jacks can eat a bowl of dicks. I never use on under my car unless desperate.
×
×
  • Create New...