Jump to content
SAU Community

Recommended Posts

Its the leak yes, It happed to me before...

What it is that, where steering arm located it has Plasric/rubber cover is torn at the top.

It possibley make some kind of winding noise if you try to turn the steering wheel.

check your fluid tank and the rubber.plastic sleeve cover on steering arm.

even resiviour is full if there is leak on the top of the steering arm sleeve.

if your power steering resiviour bubble when car is stationary or not(turning). means there is leak some where.... ( my guess would be those one of steering arm rubber/plastic covers.

Run your fingers over them (squizze them) to check for leaks.

also if mechanic is the only option can someone make a recomendation?

Hey, i have the same problem, just yesterday the HICAS sign decieded to pop up, in the past all i had to do was top up the fluid! but not time time :) mine doesnt make any sound thou !! fluid is fine doesnt bubble so im hopeing its just a leak?? should put it up on the ramps go have a look!

I noticed this grinding noise the other day whilst parking my R32 gts.. under the fluid resivouir i notice there's alot of dirty fluid where it looks as its been leaking (i've been topping it up).. i'm putting the car on the hoist tommorow to check the suspension anyway, so while i'm there i'm going to drain the ps fluid and check all the hoses

even resiviour is full if there is leak on the top of the steering arm sleeve.

 

if your power steering resiviour bubble when car is stationary or not(turning). means there is leak some where.... ( my guess would be those one of steering arm rubber/plastic covers.

 

Run your fingers over them (squizze them) to check for leaks.

The sleeve which is called a rack boot does not seal the fluid.

The rack seal stops fluid coming out of the housing. If there is any fluid inside that boot then the seal is broken. The boot only stops dirt from getting inside to where the seal is.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • That's not a transistor --- it's marked ZD1 which makes it a zener diode. As to what the breakdown voltage is, not enough there to divine.
    • Hi all, Long time since I've posted here. Looking for some advice on what I can remove to further identify the cause of my issues.  I can move the passenger seat forward and back but the knob used to adjust the seat angle is pretty much free spinning, there's very little resistance.  Removing the side cover I can see that the chain is intact but the shaft for the adjustment spins without the gear attached to it moving.  What's my next step for disassembly here? Is this a common fault? Just being a little cautious as I didn't want to start removing bolts for a spring to fly out or something equally as stupid.  Cheers
    • The incentives are mostly the same, yes. Ethanol is cheap compared to the cost of doing 98-100 RON with crude oil alone. 87 to 93-94 AKI all with E10. In 2020 Canada mandated E10 as a part of their "renewable fuel standard" and is supposedly going to go to E15 in 2030. In California where there are only 8 refineries with two threatening to shut down next year it's been over 20 years now of E10 and 91 AKI maximum because there's just not enough refinery capacity or crude oil supply relative to the demand for premium unleaded fuel. And CARB's low carbon fuel standard means functionally none of the diesel available at the pump is made from crude oil anymore. It's almost all entirely 20% biodiesel blended with 80% renewable diesel (hydrotreated vegetable oil) now. The number of gasoline vehicles that support E15 or higher ethanol concentrations is surprisingly low, I can't imagine it being wise to play tricks like this without flex fuel sensors in most of the fleet.
    • It's almost certainly the same as the one next to it. Have a fish around amongst these hits https://www.google.com/search?q=surface+mount+transistor+m33&sca_esv=9cb49794e0b2005d&source=hp&ei=2vJ5aNjTB7Kw0PEPldnS8QM&iflsig=AOw8s4IAAAAAaHoA6qkfmF6XcygtrZ4Vu9f92NXF_RFd&ved=0ahUKEwjYqIPP7MWOAxUyGDQIHZWsND4Q4dUDCA8&uact=5&oq=surface+mount+transistor+m33&gs_lp=Egdnd3Mtd2l6IhxzdXJmYWNlIG1vdW50IHRyYW5zaXN0b3IgbTMzMgUQIRigATIFECEYoAEyBRAhGKABMgUQIRigAUjKCFAAWABwAHgAkAEAmAHfAaAB3wGqAQMyLTG4AQPIAQD4AQL4AQGYAgGgAuYBmAMAkgcDMi0xoAfMBLIHAzItMbgH5gHCBwMyLTHIBwU&sclient=gws-wiz
    • South Australia, which is hardly as far behind as the rest pf Oz makes out, and who is also not a paragon of progressiveness (read that as over-legislation) in the area of vehicle standards, has this to say on the subject: Adjustable coil-over suspension Aftermarket adjustable coil-over suspension components are suspension units that incorporate an external thread on the main body and corresponding threaded spring saddle that allows the vehicle's suspension height to be varied. If fitting aftermarket or coil-over suspension components you must submit an Application to modify a light motor vehicle form and a report from a light vehicle engineering signatory (LVES).
×
×
  • Create New...