Jump to content
SAU Community

Recommended Posts

hehe

Hi everyone,,

Well its time to find a new home for my much loved afro-mobile,,

It’s an off-road go-kart which will be suited to large paddocks etc.

Its basically stock standard , besides the following mods ,, :wassup:

Suzuki GT-250 Motorbike engine,

2-Stroke

Twin Cylinder – Twin Carbi engine

Twin exhausts,,

Hydraulic disc brake on the rear axle

Engine has its own oil tank which means no pre-mixing of fuel and oil is required.

Four point harness

Fully padded roll-cage

“6” Speed gearbox – (just like a R34 GTR, hehe) :P :bahaha:

It does about 80 to 90km/hr

But can go faster if larger diameter wheels are used or gearing is changed.

Do doubt I had to add a touch of Nissan in there somewhere,, so its got a Nissan silva seat,,,

Would like to see it go to a good home,,

Priced to sell a.s.a.p

$900 ono (will consider all reasonable offers)

Prefer Brisbane buyers (might be a little bit too big to send through the post)

AFRO

Ph:- 0401 453 756

Brisabne

ya built to plans, but ended up modifying it to make it stronger,,

the design on the plans needed improving,,

my dad and i are Mech Engineers :) ,, thats good enough isn't it,, hehehehe

should have riced it up a bit aye,,,!! loll

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I think he was only proposing to use the wire, not the sender. Simply because it runs from the right place to the right place. Personally, I wouldn't hack up the factory wiring like that. I'd just lay in the Defi loom.
    • From memory it wasn't too hard to simply see which wire ran where when you plug that in. Unfortunately also from memory the OEM sender does not use the same configuration 99.9% of gauges run. So in other words if you connect the signal wire that was running to the OEM gauge to your DEFI gauge you might find your oil reads at 200C or some other incorrect value. I remember having the same line of thought and then running new wires/senders to match the gauges I have. The pinout is available in the R34 workshop manual.
    • Does anyone on here know which wire on the GTT triple gauge pod harness is for the oil temp gauge? my sensor works fine but I upgraded the gauges to DEFI advance. And if I can simply piggyback off the oem oil temp wire to the Defi oil temp sensor wire that would make life so much easier. 
    • Even face her a wash now that’s it worth more than my house
    • This was what I was invisioning, or Pete cutting a beer can up and hose clamping it around the catch can! Ha ha ha
×
×
  • Create New...