Jump to content
SAU Community

Recommended Posts

I'll be there - hoping to lower my PB to a mid 13 (or thereabouts) from the 13.9 I did a couple of weeks ago before the car was tuned. Traction will be the issue though - damm Falkens! :)

It would be good to get a heap of Skylines out there on the night and hopefully the weather is dry and cool(ish) - looking forward to it.

Link to comment
https://www.sau.com.au/forums/topic/65764-wsid-2305/#findComment-1228671
Share on other sites

it will be fine :rofl:  

http://mirror.bom.gov.au/products/IDR032.l...oop.shtml#image

I will be spectating.

Yeah, the radar looked ok mid morning, but it's not looking so promising now...there's rain areas popping up everywhere :rofl:

I'll check it again in an hour's time, but if it's not looking any better, I'll probably give it a miss and look to get out there next week instead.

Link to comment
https://www.sau.com.au/forums/topic/65764-wsid-2305/#findComment-1233833
Share on other sites

Outdoor temp here is 22.4c

This time the last 3 meetings its been up around 28c which means hopefully it will be under 20c by the time racing starts :rofl::)

Now all I have to do is workout a way to get my jack/wheels there :rofl:

Link to comment
https://www.sau.com.au/forums/topic/65764-wsid-2305/#findComment-1233905
Share on other sites

Sorry guys, I'm out - the radar is showing a heap of showers heading towards Penrith and I'm guessing that it'll probably continue along to WSID as well which is pretty annoying. I was keen to run tonight, but I don't want to rock up to get only 1 or 2 runs (if that) because of the rain. I'll definately be there next week though...

Good luck ben if you still decide to go tonight :rofl:

Link to comment
https://www.sau.com.au/forums/topic/65764-wsid-2305/#findComment-1233970
Share on other sites



  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...