Jump to content
SAU Community

Brakes will be needed soon ... need help!


Recommended Posts

Guest Nismo_Freak

I got a S14 at the moment and as we all know the 5-lug Nissan Sports cars ... Skyline, Z, and Silvias all have interchangeable brakes. I would like to source some aftermarket R33 GTR Rotors and a set of stock 4-pot Calipers. I also would need the rear units as well. Can anyone give me some help as to what the calipers and rotors would cost? I prefer the rotors to be slotted and not cross-drilled and perhaps larger :(

Thanks alot,

Alan

Link to comment
https://www.sau.com.au/forums/topic/6806-brakes-will-be-needed-soon-need-help/
Share on other sites

While we're on the subject of brakes, I have a set of GTR disks that I'm planning on fitting to my GTS-t. The idea I had was to put a second set of GTS-t 4pot caliper on these disks. I know I will have to upgrade the brake master cylinder, but can anyone suggest whether this is a good idea or whether I'm living in fairy land.

My mechanic reckons he can do it, it would look like some of the JGTC car's which run double calipers.

Feel free to bag me out if you see a flaw in my thinking.

See'ya:burnout:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • That looks good, but I think you're going to need much beefier side skirts now.
    • They are daft and there's a reason it never caught on. Steering feel? We don't need no stinking steering feel!
    • I gotta pull you up on this. It's driving me crazy. A shutter is something that closes, like over a window or in a cmera. The word you want is shudder. That LSD is clearly f**ked. Take it to a diff shop and get it disassembled and examined by an expert. YOu might have plates welded together or something equally crazy.
    • Define "starting to fail". Wy not just rebuild them?
    • Check the Nistune doco. There are a few assumptions being made here that might not be valid. I will list the things that occur to me: Base map. Base map for what? Base map for Z32? Then the cranking pulse width is probably wrong for an RB25. The extra 500cc of capacity might well be enough to prevent it from catching. Base map for RB25? I don't think you can load one of those into a Z32. You have to just make the settings correct for an RB25 in the Z32 base map. That is either K or the TIM to get the pulsewidth right. Loom. You bought a loom for an RB. And you plugged it into a Z32 ECU. Did you make sure that any iwre differences were swapped. From memory, there's at least a couple. And as per the others, I would suggest making sure that the fuel pressure is correct while cranking and that the injectors are actually flowing as expected. They really must come out and go on the bench, unless you do find that you have messed up as per above points. I would also suggest watching in Nistune to make sure that everything is reading correctly. That the correct binary flags are raised at the right time (like the crank signal), that there's no stupid values in K or TIM. That you have not got mismatched firmware for the ECU and/or a wrong image loaded.
×
×
  • Create New...