how to conect z32 to r33 gtst s2 (3 pins)

[zoom]

Would any one know the pinout for the R33 s1 AFM (3 pins). thanks..

[Trust33]

I to would like to know.Then can a mod throw it in the how to section as this is a regularly asked qustion.

[paulr33]

http://www.skylinesaustralia.com/forums/sh...ead.php?t=69487

[Abo Bob]

So can anyone add to the infor required as to R33 series 2 and R34 in this or the other thread?

I'm just about to do this and wouldn't have a clue.

Thanks.

[Trust33]

I have the same queries.I have sent cubes a pm to see if i can get an answer.

Untill i read the thread by cubes i was undr the impression that i had a s1 motor.

Luky for me i didnt go and get any parts for a s1 and realise that they would not fit.

What are the identifying traits of a s1 engine compared to a series 2?

[Trust33]

Wont know untill some1 can get a pic of the r33 s2 afm 3 pin out wire colours.

email me at [email protected]

[Trust33]

I have done some tests with the help of cubes.And i have determined that,In order of the afm flow,that wire number;

1.12v

2.Air signal ground

3.signal wire @ 1.4v

What we have to find out is it safe to run the Z32's 12v feed to the ground and why.Can i get some help from others on this question please.

Thnx cubes & zoom

[RB30-POWER]

If you want to wire a Series 1 (4 wire style) plug to a Series 2 Loom, you just have to add the extra earth wire for the power supply side of the AFM.

The factory Series 1 earth that the series 2 doesn't have is wired to the front of the plenum with the rest of the earths.

If that helps.

[zoom]

i've done some testing myself also and found the following:

1. Power 12V connecting to pin 49

2. Air Signal ground to pin 26 (note it's not ground)

3. Air signal to pin 27.

So to wire the z32 to s2 afm as follows:-

Z32 AFM R33 S2

A - not connected

B - Air signal -> 3

C - Ground -> to ground

D - Grd signal -> 2

E - Power 12V -> 1

F - Not connected

can anyone correct me if i'm wrong?

[Trust33]

That to me makes sence.The earth wire on the z32 being a 12v ground.And the air signal ground on the s2.

[wilch]

The ground wire for the z32 afm isn't attached to anything on my r33 s2. The only wires that are connected are the AFM ground, AFM signal, and 12v.

It works fine.

[The Dan]

Just finished wiring up another one so I thought I would add something a little more simple.

E --> Black/White

D --> White/Blue

C --> Direct connect to vehicle body using ring terminal etc.

B --> Orange/Blue

{First colour denotes colour of wire. Second colour is trace colour}