Jump to content
SAU Community

Sold

TUF-200
 Share

Recommended Posts

Oosh Veteran

Oosh

Posted
Posted

Hey there,

Rims:

What offset are they?

How scratched are they, etc, any close-ups of each one?

Tyres:

How much life is left in them, what brand/model and width are they?

And where abouts in Adelaide are you?

Link to comment
https://www.sau.com.au/forums/topic/69971-sold/#findComment-1294377
Share on other sites
MooroS13 Apprentice

MooroS13

Posted
Posted

Do you know what the offset is??

How would they go on an S13?

Were they redrilled to be multi-stud or from the factory?

Also what size tyres do they have on them?

Not questioning you but are you 100% sure they are 9.5" at the rear. From the pic they don't look that wide. I would probably prefer if they weren't cos I'm not sure if it will fit under s13 guards.

Link to comment
https://www.sau.com.au/forums/topic/69971-sold/#findComment-1297488
Share on other sites
TUF-200 Rising Star

TUF-200

Posted
  • Author
Posted

Dunno the offset but it fits perfect on the S14. They r factory 4 and 5 stud. Tyres are 235 x 40 x 17 front and 235 x 45 x 17 rear. Ive had them measured and the rars ar 100% 9.5". They did have 255s when the pic was taken. Will trade for $1000 ono + a set of stock/other mags as long as they fit the S14.

Link to comment
https://www.sau.com.au/forums/topic/69971-sold/#findComment-1305902
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Dose Pipe Sutututu
      new 1.5 LSD issues/concerns

      By Dose Pipe Sutututu · Posted

      Have you flushed the initial fluid yet? It should look like a rainbow unicorn shat glitter into it. 2nd or 3rd fluid change is when you party.
    • JC71
      new 1.5 LSD issues/concerns

      By JC71 · Posted

      all brand new unit from Tomei, fluid, bearings, etc. Tomei said they call it a 1.5 lsd because its 100 percent lock up under acceleration and 50 percent under deacceleration.  as I mentioned I used their fluid, install and their break-in procedure, (alot of figure 8's) but even when driving straight, or even slowly backing out of garage for first time, (at 2 mph) then driving to and from figure 8 parking lot, each tire in the rear would sporadically grab, skip, bounce, shutter and skip, shutter back a force I could feel causing clutch to slip then grab, at any speed. shaking entire car. I removed unit, since I put stock back in and all is fine, via process of elimination, its something with the lsd unit itself. I wasn't going to beat up the entire car more or change anything else for no reason as I had a feeling something in the lsd itself was wrong as everything was fine before this alone was installed and I rechecked over everything else after first time backing out I suspected an issue. I'll probably sadly already need new tires now just from trying to drive it 5 miles and performing the figure 8 break in. but if someone has any ideas I'm all ears 
    • PranK
      Most women will agree that parking is the most taxing part of driving

      By PranK · Posted

      Go back and watch the video again... 
    • funkymonkey
      Most women will agree that parking is the most taxing part of driving

      By funkymonkey · Posted

      Are you meant to double fist them?
    • Kapr
      Boost cut after swap(RB25DET NEO) R34

      By Kapr · Posted

      Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
×
×
  • Create New...