Jump to content
SAU Community

Recommended Posts

Speak to Zoran at [email protected] or call 0296014474 as they comply and stock them so you will get a good price, not many good GTiR's coming up these days and they snap up what they can.

You dont need a broker, speak to Zoran about a plate and contact Mark Hocking at www.mytrading.org about getting a vehicle if you want to personal import.

Link to comment
https://www.sau.com.au/forums/topic/77580-gti-r/#findComment-1419694
Share on other sites

Why thumbs up for somebody who will just ring Simon or Zoran in Sydney and see what they have in stock or order a plate after looking at Japan Auto Direct or Motorworld Japans site.

Look at the DOTR's site and call up the workshops and see what they have in stock, dont need to pay somebody $1,200 to do that.

http://raws.dotars.gov.au/rawswebpublic/rawpubmain.asp

Here is you first two numbers to call.

SHOGUN CAR COMPANY PTY LTD Mrs Megan Borissow Phone 07 38681377

SYDNEY COMPLIANCE CENTRE Mr Simon Fell Phone 02 9601 4474

Link to comment
https://www.sau.com.au/forums/topic/77580-gti-r/#findComment-1426964
Share on other sites

Why thumbs up for somebody who will just ring Simon or Zoran in Sydney and see what they have in stock or order a plate after looking at Japan Auto Direct or Motorworld Japans site.

why bother making a comment like that, when he's merely expressing he's good past dealings with them? He never said anything about it being THE best or cheapest way of going about it, it was simply a recommendation.

Link to comment
https://www.sau.com.au/forums/topic/77580-gti-r/#findComment-1427175
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Steam valve seals are usually responsible for cold start smoke, it goes away once engine warmed up. Disconnect it let engine breathers and let it breath freely, see if problem goes away after a short drive. Also check to make sure engine oil drain pipe is not blocked or kinked. 
    • Haha thanks! Yea I'm moving over from 2x 1000cc jets pre throttle over to 6x 190cc direct port jets and 1x 500cc pre throttle jet.  Direct port comes with all the advantages you would expect, except that pre throttle does cool down IAT'S more. That's why my direct port nozzle placement is closest to the plenum as possible in the runners to allow the air more time to cool before being sucked in. I'm also putting that one 500cc pre throttle jet to help with more cooling. It's a hybrid system. There's a lot more advantages to moving over to a PWM solenoid with a constant pressure system vs my old PWM pump setup, but I'll get more into that once I'm done converting everything over. The ricer in me is excited to see SS tubing all over my manifold though!
    • Very cool, see what I did there? 🥲 Wild WMI setup, first I've seen where it's on each cylinder runner, usually I see a single jet pre throttle.
    • Welcome mate. What type of work were you looking at getting done? Majorly of decent skyline workshops are in the SE.
    • Thanks mate, haha that's it ey, no more boosters and what not, should make for a good time
×
×
  • Create New...