Jump to content
SAU Community

whens the next cruise on???


Recommended Posts

  • Replies 62
  • Created
  • Last Reply

Top Posters In This Topic

Its pretty hard to tell the difference between VB and Tooheys New. About 95% of the people cant tell the difference. Even if you say you can i dont believe it. The only real difference is is the colour. I tell you a few funny stories which proved this thoery to me.

When i was doing a bar cource last year, i was bored so i decided to do it, the guy in charged hooked up the keg and we started pouring. He told us it was VB and about 15-20 people poured a beer and drunk it until the keg was finished. Maybe we were just retards but NO ONE picked that the beer was in fact Tooheys New and not VB.

Ive done this to a lot of people and nearly everyone hasnt picked it. Now i dont care if its VB or Tooheys New.

I like Stories.......

Hype - I'm out that way too. We should meet up some time.

Me at St Marys.

Ryan - There are heaps out our way.

They just come out when the weekend is nearing....

eheah I have two normal beers and i'm out! :uh-huh:

Can't drink beer at all... but gimme spirits and we'll

play who can skull the fastest and falls to the floor

first! :dump:

but remember... they have to be lolly drinks..

Is it me or all you see after that is :boobs:

hahah i knew i was going to use that one day!!!

DLuded, that's cause these people at the bar course we're training to work on the wrong side of the bar ! I spend most Friday nights at a table with about 9 mates and 6 jugs of new each round .... that's where you learn the difference :)

Starting to look like we'll need to organise a "no car cruise" and get together for some drinks ;)

Guest Da_Man

You guy are killing me I've just been reading through some threads and came across this, and what a laugh i've had....

All I know is that after about 8 beers it all tastes the same cause your (well I'am) pissed and can't tell...

Well anyway back to the thread " The Next Cruise" if you guys are planning anything let me know it looks like Onarun and myself are neighbours. So if you's do plan a cruise on Friday drop us a email [email protected] or give me a call 0414 867 446.

Ok hope to meet some of the guys on Friday, by the way I don't have a engine in my car so i'll come with a friends skyline if not i'll just borrow it :lol:

Later

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
    • The annoying part about neglect, is when you start to replace one thing, and find ten more broken things. Ham fisted monkey repairs you normally only find out about when trying to do something unrelated! Ha ha   Neglect you can kind of anticipate the huge costs to fix it all. Ham fistedness is normally a shock the first time your work on a new old car, as everything "looked" good before.
    • For DBA, check out their guide table here. https://dba.com.au/wp-content/uploads/2023/01/Direct_Replacement-Guide-2021.2.pdf   Additionally they have some other guides and info on how to make sure you choose the right pad.
×
×
  • Create New...