Jump to content
SAU Community

Recommended Posts

Originally posted by GTS-t VSPEC

Ken, I hate annoying the other drivers, will only lead to the inevitable. I always make sure I have enough room and time to avoid any incident, otherwise I just back off:D

See'ya:burnout:

*thinks, is this the same guy who approached a 90kmh bend at ....err ... in excess of 90kmh ??*

Cheers

Ken

  • Replies 103.8k
  • Created
  • Last Reply

Top Posters In This Topic

  • GTS-t VSPEC

    20904

  • Nizmo

    13582

  • SHUTO-BOY

    6636

  • skyzerr33

    5353

Originally posted by Neo

Ken

Glad that you did not use flash photography on the run this time. It makes you a bit paranoid on the freeway.ha ha

Nah , was too dark and shitty for any video or photo work.

Besides , 1hr of follow the leader is a little boring on camera.

cheers

Ken

Originally posted by Neo

Yes a dry day would be nice. Although a cold winters early morning is just what the old lass needs

My old lass stays in bed on those mornings and says to get your own breakfast

Cheers

Ken

Originally posted by GTS-t VSPEC

Hehe, that was cause Troy drives like a p u s s y. He said: "I was doing 15km's over the limit, I'm not going any faster":bahaha:

Poor Kyles must have been bored shitless:D

See'ya:burnout:

I think it was the sideways launch and *****ff down the road on Leach hwy that woke her up from her slumber.

A set of tight buns and a nerd wars plate can only get the attention for so long...

Cheers

Ken

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Let large companies that are making money off selling kits do the preliminary engineering for you. If they all do -10, then that is all you'll ever need. 
    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
×
×
  • Create New...