Jump to content
SAU Community

Recommended Posts

BenQ PB6100 Projector

The BenQ PB6100 digital projector is a prime solution to your entry-level SVGA projector needs. Featuring an exceptional brightness of 1,500 ANSI Lumens and utilising the latest 12° DDR DMD DLP™ chip technology, the PB6100 produces impressive digital images. This projector has an excellent 2000:1 contrast ratio and includes P-Scan, PIP and HDTV compatibility supporting up to 1080i.

The BenQ PB6100 also comes equipped with 8 sets of user pre-set modes that allows for convenient and flexible viewing. With its portable weight of 2.6Kg, this digital projector provides quality digital viewing in a variety of environments at a competitive price.

Selling because i need more money for my car and dont use it enough.

Was good fun playing GT4 on PS2 using your whole wall!!

Cost about $1900 when new, hasent been used much. Works perfect.

Asking $800 + Postage

Email [email protected] or PM me.

Here is a link i found to the website:

Projector

PB6100_99.J8677.B12_580387109pb6100.jpg

Edited by BAILED
Link to comment
https://www.sau.com.au/forums/topic/88538-benq-pb6100-projector/
Share on other sites

  • 2 weeks later...
  • 3 weeks later...
  • 2 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I like they don't raise their hands into the air when they shift their sequential boxes, seems to be a thing here in Australia lol...
    • I'm not normally one for posting random videos, but I thought we'd all appreciate the honesty about how broken our cars tend to be lol. Genuine skyline life here.   
    • New CAS just turned up from NZ Wiring. Looks like a nice bit of gear.  So, yeah. Triggered, bro. Realised I may as well do the cam belt while mucking about with it so will order one of them.
    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
×
×
  • Create New...